This operates (Winbond Hardware Doctor) when processor = 100% (e.g. AVG scan maxes out at 100%) at about 62 deg C. (not overclocked)
"No Load" temp = ~50 deg C.
It has a big Zalman "Flower" cooler.
At same time "system" temp = 35 deg C
PWM (?) = 45 Deg C
Is this OK or should I take the heat sink off, clean up and apply a new THIN film of Arctic Silver?
Thanks.
"No Load" temp = ~50 deg C.
It has a big Zalman "Flower" cooler.
At same time "system" temp = 35 deg C
PWM (?) = 45 Deg C
Is this OK or should I take the heat sink off, clean up and apply a new THIN film of Arctic Silver?
Thanks.