• Notice regarding image hosts and attachments. See here.

Packard Bell x2414 case help needed

Associate
Joined
13 Sep 2003
Posts
805
Location
Doncaster
Does anyone have any experience with this case?. Want to remove the dvd writer, but cant figure out how to get the front off the case. Tried sliding the writer back into the case but that wont work. Doesent seem to be anyway to get the right side case panel off, and front will only partly come off after moving the plastic clips I can get to. Looked for some instructions on the Packard Bell website, but doesent appear to be any archive stuff on there. :(:mad:
 
Last edited:
find the clips sticking out, move them about while pulling on the front of the case. should work, otherwise i say snap the clips rip of the front replace the drive and glue the front in place XD
 
I experienced a case front like thiswhen doing my carboot mod. it's essentially about 6-8 barbed clipsaround the edges of the front panel however some are really hard to get at and need a screw driver and an acceptance that you will lose skin from your knuckles. Don't worry too much if you break a few as it will re attach fine.
 
Well to conclude on this, I managed it in the end, though it really did feel like it could have broken at any point during the process - proper POS (unhooked the clips I could see and gave it a controlled yank). And getting it back on was even worse. Whichever retard designed the case, should be shot in the face with a blunderbuss loaded with his own s**te.

cheers
joe
 
There was an easier way, take the power supply out, the DVD drive slides out lovely backwards then :)

Have had to work inside many of these horrible machines.
 
There was an easier way, take the power supply out, the DVD drive slides out lovely backwards then :)

First thing I tried, but something was stopping it (maybe the case slot was only large enough for the back end), and I could imagine the writer bezel breaking off if I'd forced it.

Horrible indeed.
 
Back
Top Bottom