Please check this spec for me

[Uncle Petey]

Oops, forgot that 140mm fan screw holes aren't 140mm apart...
A few squares of double side tape should take care of that.

 

[ChrisD.]

I'm tempted to get the 7 typhoons and be done with it. Just single ones.

 

[ChrisD.]

Trying to use this as guidance:
http://forums.overclockers.co.uk/showpost.php?p=25266895&postcount=191

 

[Uncle Petey]

Single GT's would be fine.

Scotty's build is lovely. His latest build is probably closer to what you're trying to do: http://forums.overclockers.co.uk/showpost.php?p=25732958&postcount=405. I'm betting you've probably seen it already.

If you start at around page 100 here, there are lots of ideas to be found.
It's a massive thread, but you can generally skim for pics.

 

[ChrisD.]

Cheers. Still trying to work out a drain solution. Which connections should I use going into the T piece? Going with normal compression fittings, in which case I should have enough spare with the other 6 pack plus one single one left over. Tubing also ordered, think I'm done.

 

[Uncle Petey]

If you were to use QDC's with one permanently on the T fitting and the other on a length of hose, ready to attach when you wanted to drain, then something like these:

http://www.overclockers.co.uk/showproduct.php?prodid=WC-143-KA&groupid=962&catid=1529&subcat=2305
http://www.overclockers.co.uk/showproduct.php?prodid=WC-146-KA&groupid=962&catid=1529&subcat=2305

Or you could use a tap fitting (or a fancy bitspower one) and screw in a bit of tubing with a barb/compression when you wanted to drain.

Ed: You'd also need a male to male adaptor for the tap>T like this.

Sorry for no basket, I've got stuff in there.

 

[ChrisD.]

Don't worry, not bothering with them, a T piece with a length of tube with a temperature stop on the end should do me fine. The case will be on a desk anyway, so mavity will be on my side and the last few bits of liquid can be helped with the pump.