ahh this time it stopped a lot quicker
FSB 430
Multi: 9x
here are the results and temps - please advise if that is running too high?
2nd results at 3.8ghz
it failed using these settings:-
Ai Overclock Tuner: [Manual]
OC From CPU Level Up: [Auto]
CPU Ratio Control: [9]
FSB Frequency: [430]
FSB Strap to North Bridge: [400M]
PCIE Frequency: [100]
DRAM Frequency: [800]
DRAM Command Rate: [2T]
DRAM Timing Control: [Manual]
CAS# Latency: [5]
RAS# to CAS Delay: [5]
RAS# Precharge: [5]
RAS# Active Time: [15]
RAS# To Ras# Delay: [Auto]
Row Refresh Cycle Time: [Auto]
Write Recovery Time: [Auto]
Read To Precharge Time: [Auto]
Read To Write Delay(S/D): [Auto]
Write To Read Delay(S): [Auto]
Write To Read Delay(D): [Auto]
Read To Read Delay(S): [Auto]
Read To Read Delay(D): [Auto]
Write To Write Delay(S): [Auto]
Write To Write Delay(D): [Auto]
DRAM Static Read Control: [Disabled]
Ai Clock Twister: [Auto]
Transaction Booster: [Auto]
Boost Level: [0]
CPU Voltage: [1.4500v]
CPU PLL Voltage: [1.6v]
North Bridge Voltage: [1.59v]
DRAM Voltage: [2.20v]
FSB Termination Voltage: [1.5v]
South Bridge Voltage: [1.150v]
Loadline Calibration: [Enabled]
CPU GTL Reference: [0.63x]
North Bridge GTL Reference: [0.67x]
DDR2 Channel A REF Voltage: [Auto]
DDR2 Channel B REF Voltage: [Auto]
DDR2 Controller REF Voltage: [Auto]
SB 1.5V Voltage: [Auto]
NB LED Selection: NB Volt
SB LED Selection: SB Volt
CPU LED Selection: CPU Volt
Voltimeter LED: Disabled
CPU Spread Spectrum: Disabled
PCIE Spread Spectrum: Disabled
What can I change on my bios to try and have a better chance of acquiring 3.8ghz?
Please help guys..
Thanks
