Sparky__H
Sparky__H
My router has been playing up for a while now but a quick reset has normally fixed the problem.
Now everything fails to get through except HTTP traffic over port 80, however if I use the firmware HTTP front end to re-apply the port forwarding settings, then everything starts passing through properly again.
Doing this every single morning is becoming tedious...
Setup:
Router >> Crossover Cable >> Netgear Gigabit Switch >> PCs & Servers
Router >> Patch Cable >> Access Point >> Laptops
The router is a Netgear RP614v3
Is it new router time as I fear?
Now everything fails to get through except HTTP traffic over port 80, however if I use the firmware HTTP front end to re-apply the port forwarding settings, then everything starts passing through properly again.
Doing this every single morning is becoming tedious...
Setup:
Router >> Crossover Cable >> Netgear Gigabit Switch >> PCs & Servers
Router >> Patch Cable >> Access Point >> Laptops
The router is a Netgear RP614v3
Is it new router time as I fear?
