Project Moonwalker

man do I hate spraying....

to get any sort of decent look seems to require lots of coats and sanding in between each.

So far I have done 3 primers, a sanding in between each... and then one black. Going to add a further 2 blacks tomorrow.

IMG_20160927_211834.jpg


IMG_20160927_211847.jpg


IMG_20160927_212836.jpg
 
Almost finished.... The decals were quite hard getting on and some arrived with bubbles that were very difficult to get out. The big one on the right has about 3 bubbles :(

Still awaiting on two posters - the marquee and the one for the buttons. Ones they arrive I can put my actual buttons in and set the system up.

Havn't spray the inside drawer as i will be getting a mouse mat. I also need to order the speaker grills too.

rsz_1this1.jpg


leftside.jpg
 
I like the right side and front, not so much the left side. I would have the same decal as you have on the right side flipped to fit on the left.

Did you pop the bubbles with a pin and squeegee them? if they're still there they're not bubbles they are creases, try some heat.
 
14523276_10157665104895595_793511687901348857_n.jpg


Just waiting for my speaker grills to arrive now... and wire those bottom buttons. Other than that ... this is my finishing look :)

You can see it in action here

 
You must log in or register to reply here.
Back
Top Bottom