Project: Watery

For this update, I've gone for thumbnails.... I can't show enough detail @ 800x640... its just not fair!

So, Cobalt V8 time ladies... soo spankly and new and lovelly... I set about designing the sidepanel which I'll get cut when I'm back in the shop in about 10 days or so...













Its basically 1x 5mm of clear which is the case sructure, 1 piece of solid chromed metal (would either be ACRyan HexX or MNPCTech Modders Mesh that I'd get chromed) and then a 3mm green piece over the top... I know its not symetrical, but thats sorta the point...

Hugs and Kisses to the following:
 
AS work and SAT's practise have slowed down progress a lot.. Only a little update. I've finally got the front and rear panels sorta finished. The front will have the holes for an Aquacomputer Aquaero, while the rear with the obligitory motherboard holes, and a slot-loading Laptop drive 'slit'.

As always, these renders are done using Anti-Alias, Shadows and a simple White-Gray background.





Front Panel



Rear Panel

Hopefully I'll have got the measurments I need by Saturday and can finish this CAD and carry on with the bodging.

Hugs and Kisses to the following:
 
A little more today. I reworked the front holes to take one of the main parts of the new design, a 10mm divider plate..:







God I love Cobalt :p
 
Right CAD done!

Here is what the project should look like when finished!






( I know that the res or the mobo tray aren't drawn in - all part of my plans.)

I hope to start cutting tommorrow!
 
You must log in or register to reply here.
Back
Top Bottom