PSU Problem? Over-Heating?

Associate
Joined
9 Jan 2007
Posts
149
Hello there, apologies if this has been covered but the Search function has been disabled.

As of the past two days, the main home PC has been sporadically turning itself off, especially during games. I figured this was down to over-heating of the CPU so I removed the side of the tower and made double sure by giving the CPU fan and the heatsink a good dusting down. I also checked the system temperature and noted that it ran anywhere from 24degreesC to 45degreesC.

What further re-inforced my belief that this was a problem relating only to cooling was that immediately after it switched itself off, I would press the power button only to be greeted by a brief few seconds of boot-up before it once more switched off immediately. If I gave the PC a minute or so, it would boot-up as per usual and thus I suspected it was all down to cooling.

However, in the past thirty minutes the PC has suddenly died. It performed the usual of switching itself off suddenly. Ok, so I waited a minute or so. This time however, the power stays on and the monitor gives me the message "No Input Signal Detected. Check Connection or Input Source". Bugger, now the monitor won't pick up the PC's signal. The PC keeps on whirring and I see no action on the screen. It won't even respond to a cold restart by holding down the power button.

Now I suspect it's a faulty PSU and/or CPU.

Can someone please enlighten me?
 
Hmm. I'm running an ATI 9550 Pro, new last August. I'll switch my old MX440 back in and try it out.

This isn't actually the first time something like this has happened. Although I forgot what the symptons and effects were, last year again - we had to replace the PSU.


Update: It's just booted up first time after a long period of time since it shut down completely. I didn't swap over the gfx card either. Confirmed as the PSU then or is it down to the CPU over-heating?
 
Last edited:
Sorry just re-read your first post, and notice it says system temp. I thought that was your CPU temp. So do you know what temp the CPU is running at mate? If it does go above a threshold your PC will switch off. You can download MBM5 (Motherboard Monitor 5) and you should be able to get the temp reading from that.

If that shows the CPU to be ok, and when you swap the graphics card over and it still does it, then yes I'd say it was the PSU. But it definately sounds heat related to some component or other to me.

:)
 
he already sed his cpu runs max 45deg c...which is not hot enought to cause a pc to turn off

I would guess your gfx card is overheating or not getting enough power, either caused by a dodgy psu or an overheating psu
 
Hello. Apologies for my vagueness in relation to temperature.

I have just downloaded and installed MBM3570. For some benign reason, most likely I have no sensors in some parts - I'm returned with the following results:

temps.jpg
 
when its like that it just means you've selected the wrong motherboard when setting it up, change it

mbm is old though and doesnt support a lot of new mobos

I can make mbm monitor read my mobo as anywhere between 0 and 400 degrees C depending on which mobo i choose

my mobo temp is actually 24... lol
 
Jimothy said:
Hello. Apologies for my vagueness in relation to temperature.

I have just downloaded and installed MBM3570. For some benign reason, most likely I have no sensors in some parts - I'm returned with the following results:

temps.jpg

What mobo do you have mate?
 
Ah. I did actually select the correct mobo but eh... :confused:

Mobo: Gigabyte 8IPE1000 - G/L
PSU: Q-Tec 300W

I double checked in BIOS and it is actually the CPU Temperature. Currently it's running at 25degrees. The highest I've ever seen it is 46.

The graphics card does feel a little hot so I'm going to substitute my old Nvidia back in and see if the problem carries on occuring.


Update: I just plonked in my old card and it failed once more. The CPU is still running around 25 degrees.
 
Last edited:
Crowze said:
Replace it. Now. QTec are notoriously underpowered and unreliable.


Figured. Can you suggest a good solid PSU? I'm currently running 300W so perhaps something nearer to 400W would suffice and provide enough power for future upgrades...
 
Yeah ditch it. Those temps are fine for the CPU.

Like Crowze says, buy a new PSU before the Q-Tec takes out your whole rig. :eek:

An example of what you could replace it with,

Enermax - http://www.overclockers.co.uk/showproduct.php?prodid=CA-026-EN&groupid=701&catid=123&subcat=111

A nice 400w PSU with modular cables. £46.99 inc.VAT

Should be sufficient for your rig. :)


EDIT: If you want more future proof, incase you upgrade. Look around the 500w - 600w area.

OCZ, Enermax, Corsair. :)
 
Last edited:
Back
Top Bottom