quadgt didnt boot after changing memory timings!!!

:mad: ok, ive change for the ocz 8500 memories, works for 10 minutes then i start to run orthos for stress memories and start to fail. and i didnt any overclock in those modules.
after the system freezes and did not switch on again. apppear C1 on my mobo monitor wich means is memory. I take out and tested one module by one. One work and another one not even start the system. Hope is some factory problem since i did not overclocked the modules :(
i dont know now if i change the modules for same ones or back to the 6400 ones.
tks
 
now is working with 1 module at 502mhz 5-5-5-15 absolutely fine.
i tryed with 450mhz 4-4-4-12 but fails on orthos.
tomorrow ill try to change for new ones, but im really thinking of stepping back to 6400. im really in doubt :confused:
 
You are overclocking now! Make a note of what settings are stable and the voltage and timings used so u can dial them back in with the certainty that you are not missing something.

Id definately try to fine the CPU's limit using a higher cpu multiplier and maybe +0.1 vcore and then u can test the memory with a low cpu multiplier; balancing it out at the end.
 
You must log in or register to reply here.
Back
Top Bottom