Rear Brake Pressure Switch Leaking

[davejh666]

Hi all,

My rear brake pressure switch is leaking. The issue is I have no idea how I am supposed to replace this.



It is leaking from where those wires with the red spade connectors connect to. Now I have been told that I need one of these, just need to make sure I get the correct size: https://www.demon-tweeks.co.uk/Prod...V8DLTCh2LUAIDEAQYAyABEgLOAvD_BwE&gclsrc=aw.ds, however how does this fit?

I was pressuming that the black bit the wires connected to inside that metal housing would be the banjo bolt and would unscrew, but I have tried that and am having no luck removing it.

Does anyone have any idea what I need to do here? I have done so much work to this bike and am so close to getting it back on the road and this stupid little bit is frustrating the life out of me.

Thanks in advance.

 

[davejh666]

Ah okay, so just do away with the banjo bolt the goes down through the top of the banjo and replace it with the Goodridge one. I can then completely remove that whole housing part where the wires with the red spade connectors are?

Hope that makes sense?

 

[davejh666]

This is what is on at the moment: https://www.ebay.co.uk/itm/Rearset-...e=STRK:MEBIDX:IT&_trksid=p2060353.m1438.l2649, but the mechanic I take the bike to for an MOT said that they are not really any good and would just leak again in a few months.