Red&Black Spec Check

no you have to drill four holes 120mm apart like this

052.jpg
 
I can't remember :p but I compared drill bits to the screws I had then got some smaller metalwork drill bits and worked my way up to the right size, also you have to make a bigger hole on the part where the clips to hold on the side panels is :)
 
That didn't make sense :S?
also you have to make a bigger hole on the part where the clips to hold on the side panels is :p Or I didn't read it right
 
Might just go for a 500GB HDD and then get another as the time goes on and prices go down.


Not a fan of the case been looking at this though:
Skeleton_White_1.jpg


Would it be easier to mount a 120 Rad on the top and just not plug in the top fan :D.
I can't really fit the skelly with a rad on the side in my room, I'm isolated with space. D:
 
no, it would look horrible imo, and would be pointless using a proper watercooling setup with a 120mm rad, you'd be better going for a h60 etc

do you not have an extra 90 or so mm?

also, the 1tb is £10 more, why not get that?
 
you may as well save a tenner and go for this it is more than enough to power that system, I have an xfx 650w psu and my pc runs well :) then you can spend the tenner you saved on the 1tb drive :)

http://www.overclockers.co.uk/showproduct.php?prodid=CA-052-CS&groupid=701&catid=123&subcat=1084

also forgot to say that you will only need 6 compression fittings with that loop :)

you can :) it really won't matter :)

do you prefer that ram to this ram?

http://www.overclockers.co.uk/showproduct.php?prodid=MY-060-GS
 
Back
Top Bottom