SATA-II Jumper Settings?

[braveheart]

Anyone remove the pin for SATA-II to enable as SATA-300?? only if you plug SATA-II with same cable into port then you can remove the pin which usual default as for SATA-150 -- I dont use Floppy (IDE), ATA-133 and SATA-150 cos ive disabled and only I used are SATA-II so Ive removed 2 of Seagate SATA-II hard drive then enable as 3G - seem ok but there is no difference between 150 and 300 only you just take the pin out if using SATA-II only

 

[semi-pro waster]

Sorry, that sentence is giving me a headache but I've answered what I think you are asking. If you have a SATA 300mb/s capable motherboard then remove the jumper, if not then leave it on as not all motherboards are autoswitching. Additionally you will only notice a difference to burst speed, even the fastest SATA drives will 'only' get about 85mb/s (roughly) transfer rates sustained.

 

[braveheart]

Sorry my English still wee mess... Im trying to wee bit better English (I only blame my teacher at deaf school for not give us improvement English)

Yes I noticed the difference in burst speed. Im just trying to see when remove the pin.