• Competitor rules

    Please remember that any mention of competitors, hinting at competitors or offering to provide details of competitors will result in an account suspension. The full rules can be found under the 'Terms and Rules' link in the bottom right corner of your screen. Just don't mention competitors in any way, shape or form and you'll be OK.

Show off your 5090s thread!

Its been an expensive week but worth it :D

I tried to run it on my current Cooler Master V Series 850W from 2013 which was fine with my 4090 on 3 x PCI-E but it didn't like the 5090 so much, even though they are supposed to run on 3 x , then again its 12 years old so in went the new NZXT and it was good.

d0UN0uyh.jpg



8Z8CnOTh.jpg


My case needs tydying up a bit but I couldnt wait to give it a trial. No missing rops .. Phew!

Couldnt be happier for the next 2 years!
 
Last edited:
My Palit Gamerock 5090 arrived this morning. If anybody's interesting, here are a couple of side-by-side photos of it next to its older cousin, the Palit Gamerock 4090. The 4090's on the left, the 5090 on the right.
pozAI4Mcj

pnozOh4fj
I hope it's worth the extra cost to you but as a 4090 owner i am just not sure it's worth the upgrade. curious what you think though once you get it installed and tested.
 
An essential purchase with a new 5090 is a new 12V-2x6 :cry: ordered this when I got the 5090 last month and only just arrived, it's a new Cablemod 12V-2x6 that terminates to 2 x 8 pin on psu side.. ultra tight fit on the GPU side and currently shows very little droop under load with it sitting at 12.263v at idle and 12.067v at 600w load . Need to pick up a clamp meter to check and monitor amps . Was initially concerned about the angle the cable may sit at due the the angled plug on the FE but it's all good with no need for sharp bends in the cable :)

20250316-103614.jpg


20250316-125600.jpg
 
Last edited:
Back
Top Bottom