Stuck in Boot loop after bsod

snappyfish · 5 Apr 2014 at 22:45

Hi,

Spec as in sig below, was testing a overclock 4.4 when I got bsod after 10 mins, but now i'm stuck in a loop and it wont post to bios?? :confused:

??

Steampunk · 5 Apr 2014 at 22:50

Reset the BIOS with the motherboard jumper.

snappyfish · 5 Apr 2014 at 23:00

Steampunk said:
Reset the BIOS with the motherboard jumper.

Trying that now although for some reason dont feel like it's going to work, this board has a Clear CMOS Button which is not doing the job!

setter · 5 Apr 2014 at 23:09

Try removing the cmos battery to see if it will reset settings.

snappyfish · 5 Apr 2014 at 23:11

setter said:
Try removing the cmos battery to see if it will reset settings.

Just trying that now also.. a few minutes left out if enough?

Steampunk · 5 Apr 2014 at 23:20

snappyfish said:
Just trying that now also.. a few minutes left out if enough?

Yes, make sure you switch off the back of the PSU. Also double check the CMOS reset in the motherboard manual. Some have weird reset procedures.

If none of that works, try any BIOS rescue the board has. Are there any motherboard telltales (start codes, beeps, LEDs etc) that might tell you where the boot process is stalling?

If you're not even getting into the BIOS after a reset then that implies corrupted BIOS or even hardware failure of the RAM, CPU, etc

snappyfish · 5 Apr 2014 at 23:33

Tired CMOS Reset with battery out (after switching off PSU at back) restarted with the bios switch on back up bios same problem, the motherboard debug led code reads AE according to the manual it means "Boot to Legacy OS."

The pc stays on fans are on but nothing posts and the monitor flashes on then "no signal" apears and repeats

snappyfish · 5 Apr 2014 at 23:40

With the bios switch on main bios it gives error code A6 "Detect and install all currently connected SCSI devices."

snappyfish · 6 Apr 2014 at 00:00

Back in

Dont know why this happened new to me but took the display port cable out and tried hdmi to my tv and booted and got the load default bios screen. set the defaults and booted, everything good.

shut down and plugged back in the display port for my AOC Q2770PQU and the highest resolution I could see was 640, uninstalled all devices under monitors in device manager rebooted and everything back to normal??

Anyone know why that happened?

snappyfish · 6 Apr 2014 at 00:01

Back in

Dont know why this happened new to me but took the display port cable out and tried hdmi to my tv and booted and got the load default bios screen. set the defaults and booted, everything good.

shut down and plugged back in the display port for my AOC Q2770PQU and the highest resolution I could see was 640, uninstalled all devices under monitors in device manager rebooted and everything back to normal??

Anyone know why that happened?