So, did my first loop a few months ago and bored already, finally able to get the tools and hard tubing to upgrade the system!
My questions are
1:What tubing am I going for? I don't see the fittings listed on here ATM but in my past orders they come up as "Monsoon 1611mm (ID 716 OD 58) Free Center Compression Fitting Six Pack - Blue"
No hard tubing seems to be 16/11 so I ASSUME I need 16/12? (Given it's not going to stretch over the fittings). HELP: Does the width of the tubing matter all that much when temps come into play? Will I have better temps with wider (16mm (OD)) tubing or, can I use the smaller (12mm (OD)) and get the same results?
2: Are I still able to use compression fittings? ANSWER: GOING TO CHANGE FITTING TO EK-HDC's
3: Any tips and tricks to tightening the fittings at all? ANSWER: EK-HDC's (I'v over tighented my current ones but research has shown me I have over tighten mine out of fear)
I have a heatgun already and was looking at Easy Bend Toolkit by XSPC, other then that, I just need tubing, right?
Thanks for the help
My questions are
1:What tubing am I going for? I don't see the fittings listed on here ATM but in my past orders they come up as "Monsoon 1611mm (ID 716 OD 58) Free Center Compression Fitting Six Pack - Blue"
No hard tubing seems to be 16/11 so I ASSUME I need 16/12? (Given it's not going to stretch over the fittings). HELP: Does the width of the tubing matter all that much when temps come into play? Will I have better temps with wider (16mm (OD)) tubing or, can I use the smaller (12mm (OD)) and get the same results?
2: Are I still able to use compression fittings? ANSWER: GOING TO CHANGE FITTING TO EK-HDC's
3: Any tips and tricks to tightening the fittings at all? ANSWER: EK-HDC's (I'v over tighented my current ones but research has shown me I have over tighten mine out of fear)
I have a heatgun already and was looking at Easy Bend Toolkit by XSPC, other then that, I just need tubing, right?
Thanks for the help
Last edited: