• Notice regarding image hosts and attachments. See here.

Terminating Ethernet into a back box

Soldato
Joined
14 Jul 2005
Posts
9,744
Location
Birmingham
Don't know if better here or the networking group.

I'm planning to run Ethernet from my router (living room) to my office (upstairs box room). The easiest route will be out of living room wall, vertically up the outside brick face to soffit in conduit, into loft, across loft clipped to joist/rafters, then down into bedroom from above (rooms are on opposite sides of house).

In future I want a run to the back downstairs room of the house as well.

Whilst Im doing conduit externally I thought I may as well run multiple cables I.e two minimum or maybe even four for future proofing.

I need the cables to be able to pass through the conduit, turn 90 through the brick wall into the back of the back box and then be terminated into a RJ45 faceplate.

If there are four cables this means a double back box with a 4 way faceplate.

I've read about difficulty terminating cat5e or cat6 cable in a small space.

Has anyone done this and got any photos of how easy it is to fit and terminate four cables in a back box from rear entry?

Thanks.
 
Are you saying you are planning on running multiple cables out of your wall?

You'd be better off running one out of the router, out and up, then put an unmanaged switch (wherever is a good place upstairs/loft) then branch out from there.
 
Are you saying you are planning on running multiple cables out of your wall?

You'd be better off running one out of the router, out and up, then put an unmanaged switch (wherever is a good place upstairs/loft) then branch out from there.

Yes the idea was 2 or 4 cables direct from living room to loft, externally in conduit.

I don't have power in the loft yet plus it gets hot in summer and biting cold in winter, not keen on having a switch up there for that reason.
 
Last edited:
I'm planning to run Ethernet from my router (living room) to my office (upstairs box room). The easiest route will be out of living room wall, vertically up the outside brick face to soffit in conduit, into loft, across loft clipped to joist/rafters, then down into bedroom from above (rooms are on opposite sides of house).

Are you sure that going around the outside of the house wouldn't be easier? Fewer holes so less drilling for starters. Do bear in mind the maximum segment length of 100m - ideally you want to be well below that.
 
Are you sure that going around the outside of the house wouldn't be easier? Fewer holes so less drilling for starters. Do bear in mind the maximum segment length of 100m - ideally you want to be well below that.

I've considered going round the outside of the house, it would be the front elevation doing it that way, multiple corners and a bay window to navigate, and that just gets me a single cable to upstairs box room rather than potential future cables to more rooms.

Although any of my routes are nowhere near 100m length. A direct route round the house would be around 15m. A route up into loft, across loft and down to room would be around the same.
 
Back
Top Bottom