UT2004

ahhh cheers :D shall have a look when I get home :) with the config settings, do I have to do them each load up? only once? is there a .cfg file I can add them in like start-up parameters (for the game obv :p )

I kinda do that first video, I mean.... it's what I try xD well I'd just try switching where I notice he does the first two jumps with the same direction and then alternates. probably more just my timing than anything :)


(gotten a bit off topic sorry haha xD)

Just add the commands into the QL configs, although I am not sure which one it uses (it may be both).

It is normally located in c:/users/yourname/appdata/locallow/idsoftware/quakelive/home/baseq3/qzconfig.cfg & repconfig.cfg

(best to open them in wordpad)

Also, if playing online you should also set:

snaps 40
cl_maxpackets 125
rate 25000

I also use:

cg_fov 110
cg_drawtimer 1
cg_drawfps 1

I also turn off all screen shaking and any bob pitch/roll

There is a good guide to console commands here http://www.regurge.at/ql/#var

You can type a lot of them in the console in the format:

/cg_fov 110

Or you can put them directly into your config file in the following format: seta cg_fov "110"

OK, enough hijacking, sorry guys.
 
Back
Top Bottom