Thank you for the offer but I would like to keep using this pump/res combo since most other ones are so small and it would look silly.
The res is pretty big, tube alone is 30cm, so the water that enters from the top has ~25cm to dissipate before it reaches the pump, so I think this should be plenty for the bubbles to have time to reach the surface, ontop of the res.
They also sell this thing, I can add it in the middle of my reservoir, and attach the inlet from the rad to it, so what would mean inlet would be in the middle of the res, and all the bubles would be able to float to the top of the ress freely. That would require a set of new tension rods and a tiny new tube aswell, but they are very reasonably priced, and that would give me a chance to increase the length of my reservoir by 5 or 10cm.
Do you think that would fix the bleeding issue ?
You see the middle ring on the reservoir, that`s where the inlet would be, just to clarify visually.
It's an MMRS from Monsoon, and the top has 3 ports I am using one for inlet, one has a temp sensor and one is for filling/bleeding, ill try to bleed it better and see how it works out.
And if temps are still abysmal after proper bleeding some noctua industrial fans seem mighty tempting, they dont look terrible like the brown commercial versions, and aint that expensive either.
NF-A14 industrialPPC-2000 PWM
140x140x25
2000
31,5
182,5
4,18
4-pin PWM
Not really into RGB really.
Corsair ML Series ML140 (nonRGB) seem to be decent to and they are like ~50% cheaper than Noctuas!
The res is pretty big, tube alone is 30cm, so the water that enters from the top has ~25cm to dissipate before it reaches the pump, so I think this should be plenty for the bubbles to have time to reach the surface, ontop of the res.
They also sell this thing, I can add it in the middle of my reservoir, and attach the inlet from the rad to it, so what would mean inlet would be in the middle of the res, and all the bubles would be able to float to the top of the ress freely. That would require a set of new tension rods and a tiny new tube aswell, but they are very reasonably priced, and that would give me a chance to increase the length of my reservoir by 5 or 10cm.
Do you think that would fix the bleeding issue ?
You see the middle ring on the reservoir, that`s where the inlet would be, just to clarify visually.
It's an MMRS from Monsoon, and the top has 3 ports I am using one for inlet, one has a temp sensor and one is for filling/bleeding, ill try to bleed it better and see how it works out.
And if temps are still abysmal after proper bleeding some noctua industrial fans seem mighty tempting, they dont look terrible like the brown commercial versions, and aint that expensive either.
NF-A14 industrialPPC-2000 PWM
140x140x25
2000
31,5
182,5
4,18
4-pin PWM
Not really into RGB really.
Corsair ML Series ML140 (nonRGB) seem to be decent to and they are like ~50% cheaper than Noctuas!
Last edited: