Watercooled Antec Skeleton
- Thread starter maduser
- Start date
like this?
i changed the top fan color mode and turned of the blue & uv c cathodes. the rest of the blue leds are from the water block and the ballistix tracer mem. top fan has some nice color mixes tho green/red or blue/red etc or off
also a pic of my old raptor viewable thro the mb floor. excuse the dust tho (cough)
i changed the top fan color mode and turned of the blue & uv c cathodes. the rest of the blue leds are from the water block and the ballistix tracer mem. top fan has some nice color mixes tho green/red or blue/red etc or off
also a pic of my old raptor viewable thro the mb floor. excuse the dust tho (cough)
it can do if you get lazy like i have lately. been about 2 months since i cleaned it. then again at least if i can see the dust it reminds me to clean it so it doesnt get out of control. quick blow over with an air duster now & then sorts it out 
As i mentioned before, dust is no problem an airduster and a fine brush cant fix. Besides imo if you spend long enough time creating a masterpeice then your hardly going to neglect to clean it regularly. Building it means i know how to dismantle it so most of it i can whip out in seconds like the gfx card, psu drives etc to clean the under tray. easier than my old lanfire case
Hmm yea hehe 6 months ago iwas using my am2 board with a custom bracket and it was easy then. Bit trickier now tho but i never need to slide the tray out much so it would depend on why. So when i do i unclip the mesh section and move it back as i slide the tray. The alternative is to unplug the front panel cables unscrew the rear bar drop off the side panels then unscrew the 4 screws on the legs and remove the whole top off the chassis this is how i installed the watercooling on my new cpu & mb as it was already filled. The rad i used the existing screws the came with it, posted thro the mesh. As its my 1st modded rig tbh it all fit together like it was ment to be xD spooky!
<3 your skeleton btw looks cool nice to see a few more of them
this is how i installed the watercooling on my new cpu & mb as it was already filled. The rad i used the existing screws the came with it, posted thro the mesh. As its my 1st modded rig tbh it all fit together like it was ment to be xD spooky!<3 your skeleton btw looks cool nice to see a few more of them
Thanx a lot all, seems i didnt do badly for my 1st build
I have just aquired another water kit the same as i have on the case already. Now im not sure about it but i was thinking about using it on a duel loop rig. saddle bag it on the other side panel and use it to cool the gpu. i found some nice full cover plexi blocks for my gtx285 but they are a bit pricey. Also i could replace the tubes for clear and pump some red goo instead. Im a bit undecided as i dont want to over do it. PS i really like the way you paint the top frame looks awsome
ah yeh well spotted it is a sony speaker lol, my S.master dav-s880.
I have just aquired another water kit the same as i have on the case already. Now im not sure about it but i was thinking about using it on a duel loop rig. saddle bag it on the other side panel and use it to cool the gpu. i found some nice full cover plexi blocks for my gtx285 but they are a bit pricey. Also i could replace the tubes for clear and pump some red goo instead. Im a bit undecided as i dont want to over do it. PS i really like the way you paint the top frame looks awsome
ah yeh well spotted
it is a sony speaker lol, my S.master dav-s880.