• Notice regarding image hosts and attachments. See here.

Which case fan to buy?

alright thanks, are they easy to install? never done a fan before.

Just four screws, one in each corner, then plug the 4 pin (PWM) connector into either a fan hub/controller or the motherboard. I'm fairly sure that case has a fan "hub" but the motherboard will work fine too.

If you have used a screwdriver before you'll be fine.
 
Just four screws, one in each corner, then plug the 4 pin (PWM) connector into either a fan hub/controller or the motherboard. I'm fairly sure that case has a fan "hub" but the motherboard will work fine too.

If you have used a screwdriver before you'll be fine.

problem is i don't think i have anymore fan headers on my motherboard, i could be wrong though. i have msi tomahawk x570, i'll try and check the manual to see how many there are
 
problem is i don't think i have anymore fan headers on my motherboard, i could be wrong though. i have msi tomahawk x570, i'll try and check the manual to see how many there are

You defiantly will have plenty of fan headers. My B350 board has several. I've also looked it up, and there should be spare headers on the fan hub. Fan hub loos like this:

so2YO8H.webp
 
Last edited:
Get the pst version of the P12 fans. They can be daisy chained using the fan cable. So you would only need a single pwm header per a group.
 
problem is i don't think i have anymore fan headers on my motherboard, i could be wrong though. i have msi tomahawk x570, i'll try and check the manual to see how many there are

There are four fan headers right next to each other at the bottom of the board in the centre. I believe they are hybrid so in BIOS check to see if you want PWM or DC (voltage) type control.
 
If worst comes to worst, you could use a fan header splitter cable. Cheap and cheerful, but both fans plugged into the splitter will run at the same speed dictated by respective header
 
If worst comes to worst, you could use a fan header splitter cable. Cheap and cheerful, but both fans plugged into the splitter will run at the same speed dictated by respective header

This is what I've done, I've just bought 5 corsair ml140 fans and the front two intakes are using a Noctua 4-pin splitter connected to fan header one. I don't mind as I want them running in sync.

The top two exhaust are in header 2 and 3 with the rear exhaust in fan header 4. I've found this gives me lots of flexibility within the bios fan control to keep the case near silent unless things get too toasty lol
 
Back
Top Bottom