Which EK multi GPU bridge.

[bigdave2k9]

Some may have seen my project thread some may not... If you have seen it, you will prob get a better idea.

I'm using a Asus Rampage V Extreme Motherboard, and 2x Evga 980ti Hydro Coppers..

Middle to Middle of the PCI-E slots measure in a 1.6 inch.

I am required to use slots 1 and 3 to get 16x 16x out of my gpu's...

As much as people do it, i'm not a massive fan of using fittings and pipe between the GPU's as a method of connection for cooling..
I'm rather fond of the EK Plexi Bridges..

Enter the problem..

For use with motherboards with PCIe x16 slots 60.9mm (2.4") apart!

Unless im being totally blind.. I've looked direct with EK and i cant seem to spot a block that will fit the gap..

Could someone clarify this please..

Thank you.

 

[deFiniLoGy]

Dual Parallel/Serial 3-slot.

 

[bigdave2k9]

Dual Parallel/Serial 3-slot.

All of them are saying 2.4"

 

[deFiniLoGy]

All of them are saying 2.4"

the distance between ur slot 1 and slot 2b should be 60cm?

If you intend to use slot 1 and slot 3 (i.e. 1st and 4th slot) than u need a triple fc terminal and get another a blanking plate to blank off the middle one.

 

[tyler_jrb]

I have the same board. I too have mine in the same slots. Like defini said use a triple parallel and blank the middle off with a blanking plate as I have done the same.

https://www.overclockers.co.uk/ek-water-blocks-ek-fc-terminal-triple-parallel-plexi-wc-721-ek.html

Same as mine apart from mine is black. You can see pic in my sig.

 

[EK Luc]

Some may have seen my project thread some may not... If you have seen it, you will prob get a better idea.

I'm using a Asus Rampage V Extreme Motherboard, and 2x Evga 980ti Hydro Coppers..

Middle to Middle of the PCI-E slots measure in a 1.6 inch.

I am required to use slots 1 and 3 to get 16x 16x out of my gpu's...

As much as people do it, i'm not a massive fan of using fittings and pipe between the GPU's as a method of connection for cooling..
I'm rather fond of the EK Plexi Bridges..

Enter the problem..



Unless im being totally blind.. I've looked direct with EK and i cant seem to spot a block that will fit the gap..

Could someone clarify this please..

Thank you.

The EVGA HydroCopper blocks uses a special wider terminal per EVGA's request.

Because of that, you can't use our EK Terminal Bridges with them. You will have to go with fittings and tubing sorry.