Why are Arctic Freezer III AIO's cheap?

[BornEvil]

I have a very bad push pull set up, only for looks.
unmatched fans at unmatched speeds.

push pull will always be good, you move more air at a set PWM percentage, but in my case i didnt even test. the front fans are just for RGB looks
the stock fans do all the work

That’s a very interesting way to loop the tubes behind the 24pin, nicely done

 

[WARburton]

Yes there p12, but if your looking for extra fans or cheap good performing fans grab some p12max there amazing radiator fans

 

[WARburton]

That’s a very interesting way to loop the tubes behind the 24pin, nicely done

There a pain in the ass. I was looking for a way to keep them out of the way.
There held with a zip tie so not pulling on the plug

 

[Delta3D]

Received my III 360 ARGB the other day, went to size everything up last night and it didn't fit my Corsair 400q case, bit annoying! Advertised support for 360mm from Corsairs material too..

Had to resort back to air cooler :/

 

[freddie64]

That’s a very interesting way to loop the tubes behind the 24pin, nicely done

There a pain in the ass. I was looking for a way to keep them out of the way.
There held with a zip tie so not pulling on the plug

Agree with BornEvil. Looks so neat and tidy like that.
Who knows, you may start a trend.

 

[WARburton]

Agree with BornEvil. Looks so neat and tidy like that.
Who knows, you may start a trend.

Keeps them out of the way. Systems just don’t look nice when there all over. People spend hours missing with cables to get them perfect then just throw the AIO in

 

[Trig]

Hmm, these are quite cheap, looking to remove my x63 because, screw NZXT, wanting 280, fans I'm not bothered about as I'll swap them for the noctuas I already have..

 

[WARburton]

They are a very good cooler, for the cost there amazing. You just have to make sure you have enough room for the extra 9mm of rad thickness. 9mm doesn’t sound like much but it really is.

 

[Ross Thomson]

I had gurgling from my mk1 freezer 360. switched from front to top and the air trapped in the pump moved out. Had been in the front since new. No noises now and no temp issues.

 

[WARburton]

I had gurgling from my mk1 freezer 360. switched from front to top and the air trapped in the pump moved out. Had been in the front since new. No noises now and no temp issues.

No with the new one it’s not a gurgling, it’s then pump position. The way it’s monitored it’s vibrates. There is loads of YouTube videos.

My pump was horrible but if you pushed it a little with a finger it stopped.

However fixed at 48% it’s silent and kits my cpu cool