• Notice regarding image hosts and attachments. See here.

Worn brake pad

Soldato
Joined
5 Aug 2013
Posts
6,990
Location
Shropshire
I don't know if the outer pads on both calipers have been stuck since I put them in - they came out ok -nothing siezed that I felt.

Hopefully the judder on hardish braking has gone -not used them in anger yet - just going to run them in a bit.

These are the old pads

d5bSTQZl.webp
 
I'm no mechanic but I have done plenty of pad and disc replacements and never seen wearing like that.

I could only suggest part of your caliper is seizing. If you had juddering under braking this is an indicator as well.
 
Sticking both side ? They were the same.

It is a first for me after over 50 yrs of driving and changing the pads/disks and shoes.
 
Seen it happen a lot even seen slanted wear on pads. Happens mostly with floating calipers that have piston on one side and grab other side like a hand. Usually stuck sliders or even seen some pads like ebc which have too much paint coating on backing plate get stuck in the guides. Usually file them down a bit and put them in so they are free moving
 
Hi OP,

I had something similar on my rear brakes. The previous mechanic who changed my brakes had not greased the slide pin which meant the outer pads on both rear wheels were stuck open. The inner pads were well worn while the outer pads were basically brand new when i had them changed out. Judging by the leading edge chamfer on the pads in your image, they've hardly been used since they were installed.
 
Last edited:
Sliding calipers area total abortions and the result of less than scrupulous maintenance is what you see with the pads.

The slider pins at best need cleaning up and *correctly* greasing, at worst renewing and maybe the calipers too if the pin holes are shot.

If you value balanced pad wear above the occasional rattle leave out any rubber anti rattle O rings on the slider pins.
 
Back
Top Bottom