XSPC H2 TITAN TRI-SLI GOODNESS

pgi947 said:
As above mate, people like their names associated with big high spec builds, they might chuck you some stuff for free, they might even ask for you to show case some of their other products...from what I can see the only things that aren't XSPC are the fans and fittings.

I will own that case....one day :D

Yep, turning it on first time is always a bad part :( Yesterday I turned on, lights flickered then back off, felt like crying...derped, installed new ram and didn't reset cmos :p
Click to expand...


The case is the dogs :D


PEBKAC :p
 
Its near always PEBKAC with me :p

I've lost count of the amount of times I had forgotten to plug in the EPS connector, its one of the reasons I use a cheap OEM PSU to cycle the pumps on bleeding, means I don't have to remove any cables :D
 
Been running for a few days now and everything seems fine and dandy :)

Both D5 pumps set to 2 and fans ramp up to 1400 approx under load (very quiet) :D

Room temp of 22 deg

CPU Idle - 26 deg
Load - 75 deg Prime95 (4.8Ghz/1.42v) 75 deg is the hottest core the rest are mid-high 60's

GPU's Idle 27-25-25
Gaming stock 42-40-41
Max stable OC 51-49-48
Above temps are playing Crysis 3 as for me it generates the most heat

When I ran my cards on air temps would reach high 80's to mid 90's, so very happy with the results

The other benefits I've seen in WC my Gpu's is a gain of 39mhz on my worse card, but more importantly no downclocking :)
 
Sorry mate, forgot to say this

When you start to fit them, one at a time and don't fit the thumb screws till all the cards are fitted.

Fit the flow bridge to the card b4 fitting in the case, have a look at my thread

as pictures are better than words.

Does the top of your case come off easy, if so remove it so its easier to

to fit the screws of the flow bridges this way.

When you fitting your blocks?

I've trusted my mobile number if you need any help
 
whyscotty said:
Sorry mate, forgot to say this

When you start to fit them, one at a time and don't fit the thumb screws till all the cards are fitted.

Fit the flow bridge to the card b4 fitting in the case, have a look at my thread

as pictures are better than words.

Does the top of your case come off easy, if so remove it so its easier to

to fit the screws of the flow bridges this way.

When you fitting your blocks?

I've trusted my mobile number if you need any help
Click to expand...

Thanks Neil

I will probably be fitting them in the next week or so.:)

Unfortunately the top of my case does not come off, the front,top and back are all made out of one sheet of metal.:(
 
'enthusiast' level build incarnate.

I can't believe you're not gonna light up those lovely blocks?
BLue is so over done, whack some nice white LED's in them for a classy look, get them to glow out of phase with each other, it will really look like a warp drive PLUS you'll get higher performance if they're glowing:p
 
You must log in or register to reply here.
Back
Top Bottom