• Notice regarding image hosts and attachments. See here.

Zombie PC - A Problem...

Soldato
Joined
27 Aug 2011
Posts
5,310
Location
Sheffield, UK
Bet you all came here expecting to see a wicked case mod well I'm sorry to disappoint. The reason I called this thread Zombie PC is because lately my PC is acting very strange.

It appears to have started happening since I put a new hard drive in the PC, and yes, I removed the hard drive and the problem still occurs.

Basically, when I try and turn the PC on nothing happens. No lights, no fans, zero.

I checked all the connections and they're fine, the only way I can get it to boot is to toggle the PSU switch and reseat the 24 pin connector to the motherboard.

So my thought was either dying PSU, the 24 pin cable may have been bent too much and torn or the power block on the motherboard is dodgy.

So I think I either need a new PSU, board or at least a cable, obviously some routes are cheaper than others.

Any ideas or experience the masses can offer?
 
Could be the PSU to be honest... cheapest option, well, I don't think that there is a cheap option for making sure unless someone on here that is close to you can help.... :)

Stelly
 
I tested the PSU outside the case attached to a case fan, the PSU didn't work first time round but after toggling the power switch on the PSU the fan starts. I'm thinking it could be a dodgy wire either the kettle lead or the 24 pin connector, so I've ordered a new 24 pin cable, just wondered if anyone had any experience with this kind of thing
 
check all connections sometimes pins/sockets don't mate properly, as was said earlier set up the basics out of the case, motherboard/cpu/heatsink ,add the gpu if you haven't got onboard, one stick of ram with the PSU, connect the monitor and see if it boots into bios.
 
OK, I tried the motherboard, PSU, 1 stick of ram and the CPU cooler outside the case, it boots and immediately switches off
 
Well I did Corsairs paperclip test and the PSU is able to power a single fan, just waiting to a new 24 pin cable so I can eliminate the dodgey cable as a cause.

Update: new cable and the paperclip trick works so I guess its not the PSU, Every time I plug the motherboard, I get a boot loop, so I guess that's a short or a dead board?
 
Last edited:
UPDATE - I purchased some plastic stand offs and installed them tonight, PC booted fine, when I finished using it I turned it off, left it for a few minutes then attempted to turn the PC on again, no joy, obviously it's not a PSU or a motherboard problem, as I can still get the USB's to charge stuff, I'm thinking its a dodgy wire but where do I start? I've already replaced the PSU cable and as I said, the PC has power just won't turn on, could it be a duff case switch?

UPDATE 2: New PSU installed, boots into bios but only 2 out of 5 of my hard drives are recognised. Which is s problem because one of the unrecognised drives is the OS drive
 
Last edited:
I can't reinstall windows as my DVD drive doesn't seem to be working either, I'll have to try a few different data cables but the burning smell and lack of noise from 3 out of 5 drives is making me think the drives are toasted. Whats the typical price for data recovery?
 
Good news everyone! Something happened to the PSU which caused it to burn out 3 hard drives and my DVD drive LOL. Pretty annoyed because that's going to cost around £500 to get the data off my drives. I'm guessing corsair's warranty doesn't cover compensation claims for damaged hardware as a result of a faulty PSU
 
Back
Top Bottom