Advice for DIY install of bathroom and waterproofing walls - can I tile a dot and dabbed wall?

Shower screen and new shower
vhVGz4W.jpeg


Toilet and a towel rail which Ive had 8+ months finally fitted.

lWfmY7k.jpeg


Mirror, also some fitted cabinets. I just need to order a custom sized worktop now and over the counter sink.

P7HTKdm.jpeg
 
Thought this was an innovative one to make sure my cover panel was tight in, used a plasterboard prop

Should I bother covering the cut edges on bathroom units/cover panels before putting the worktop in? They shouldnt really see moisture. I Should have the worktop coming end of the week I hope.


dCmidfy.jpeg

0Vqo82z.jpeg

qG6GYbv.jpeg


Below picture was actually before it was glued on but you get the idea..

SzMZDgx.jpeg
 
Thanks for previous advice.

Got my worktop in and sink plumbed in tonight/last. Think the cold feed is kinked slightly so going to have to elongate it a bit. Could be tidier but it works.


Only ting left is to fit the bath panels (any tips for cutting them?)

G52jh0J.jpeg





oBQ2tfV.jpeg




TNURPCG.jpeg
PxDGrVj.jpeg
 
That's banging. I have a lot of time for the plumbing too!

What worktops are they?
Worktop express solid laminate, basically layers and layers of laminate rather than typical laminate on a chipboard base. Got the cuts measured and cut to size once I fit the units and I drilled the sink/tap holes to suit (saves any errors in dimensions


 
Back
Top Bottom