Air easily gets trapped in the Full cover graphics card coolers if thats what ya using, theres lots of fins in there over the GPU that the air gets stuck against, that was the hardest thing for me to get the air out of, lots of tilting the case around and giving short blasts of ya pump should get them out.
Air bubbles
- Thread starter rabc1690
- Start date
[email protected] is very high. I run 4.8Ghz at 1.375V
my chip def wont run 4.4 any less and thats with llc at ultra high i dont know how so many can get theres that high with such low volts, even 4.8 bi have to have 1.49v. would love to have it that high with lower volts. what board do u have
did you use the multi only to oc???
AFAIK the FX8350 is not a sandy bridge CPU
I stand corrected, totally missed that tbh, in that case, 1.4v might be needed, have 0 knowledge on AMD's Bulldozer, But I would have thought that 4.4Ghz would be easily achievable tbh,
just to add, you can overclock via both methods on BD, Block or Multi, or a mixture of both (this usually yields better results for some reason)
4.7Ghz at 1.375 on an AMD FX8350. Needs a nudge up to 1.4V for priming but for gaming and encoding, rendering tasks runs fine on 1.375V.
i dont understand how you can run that low volts for 4.7. even talking to guys on ROG etc who cool with LN2??? all say im going to need at least 1.46 upwards and a minimum of 1.49 for a 4.9 oc fully stable.
what mobo do you have and at what settings