• Notice regarding image hosts and attachments. See here.

Changing Car Bulbs

Even easier on a Renault artic truck.

I got pulled by VOSA at Sandbach for n/s blown headlamp bulb.

undo the bolt on the side footwell... Headlamp swings right outward on a hinge.

I then heard a "Bejesus be**** that's a good idea" from the Paddy parked next to me. (Scania driver)

I wonder why other manufacturers haven't adopted that idea ?

Patents ?
 
The most irritating headlight I ever changed was on my 3door Astra (2006). In order to change the bulb on that you have to turn the wheels full lock and reach up into the wheel arch and fumble around blindly untill you can pull a flap open and pull the bulb out the back! Stupid design.
 
The brake light in my spoiler has been converted to a Fog lamp now, Thought it would have been a right faff sorting it out but it turned out to be a bulb, It was as easy as fitting a light bulb, took about a minute but that includes 40 seconds staring at a Doris that walked past my drive as I was doing it. :p
 
I decided to put some different/brighter main beams in my octavia vrs.

SUCH a massive pain. You have to remove each cluster and there is a release latch with a hook that you have to pull with all the power of the universe to release the cluster.

Then i put one cluster back incorrectly and thought i had got it stuck and not in the right grooves. After countless cut and sliced fingers and many screams i finally got it out again and re-seated in the right position.

Not a fun half hour.
 
Went out to change the dipped beam bulb on my 2014 MK3 Focus, watched some vids on YT and thought ah that's **** easy... Gets light cluster out, pops rubber bung off, FFS the light bulb holder is completely different to all the ones on the YT vids. No idea how I unclip it without breaking it.

Why is everything so difficult these days?
 
Mk3 Focus is one of the eaiser ones out there lately. Couple of screws the whole unit pops out for tons of access. Many you can't get your hand into let alone see what you're doing! Headlight bulb is just a H7 IIRC, you sqeeze the tab on the plastic connector to pull it out.
 
Mk3 Focus is one of the eaiser ones out there lately. Couple of screws the whole unit pops out for tons of access. Many you can't get your hand into let alone see what you're doing! Headlight bulb is just a H7 IIRC, you sqeeze the tab on the plastic connector to pull it out.
Agreed, Mk. 3 Focus is easy, although you do need a screwdriver to release the cluster. Quite easy though.
 
Agreed, Mk. 3 Focus is easy, although you do need a screwdriver to release the cluster. Quite easy though.

You mean for the milti-plug? They release easily without a screwdriver, just need to push the connector in while you lever the tab backwards which will allow it to release and pull out :)
 
Can't replace the bulb on mine :( sealed inside the headlamp unit, so when the LED bulb goes, have to buy a whole new unit. Fiesta Mk8 when they switched from halogen projectors to LED bulb projectors.

Unless I'm wrong and that rear plastic piece is removable/replaceable?

9rwg8OY.webp


This is the cover for the replaceable halogen high beam bulb.


hDqdWa2.webp
 
@ LeeUK, I have seen YT videos about that bulb before, on the right hand side, there is a clip (long black bar) you have to press in I believe, then it pulls straight out. I might be wrong though
 
Can't replace the bulb on mine :( sealed inside the headlamp unit, so when the LED bulb goes, have to buy a whole new unit. Fiesta Mk8 when they switched from halogen projectors to LED bulb projectors.

Unless I'm wrong and that rear plastic piece is removable/replaceable?

Yeah LED units are sealed. There's no individual LED bulb you can buy to replace them.

Removing the whole front headlight requires a flat blade screwdriver?

Ah, you mean the screws holding it in? I use a T30 :p

1635059887.jpg


As I say it's completely different to all the ones on the YT videos.

As I said before, squeeze in the tab and pull it.
 
Back
Top Bottom