Computer problem

cam · 25 Sep 2007 at 17:13

Well the spec is:

E6600
Geil 2gb
fatality matx motherboard
x1950xt 256mb
corsair 520w psu

Had the motherboard replaced yet still the problem is still there.

When i boot my pc up that's all it does, sounds like its loading up/fans spinning but doesn't get further than that.

Tried onboard and the gpu card and still the same problem.

Any help please

dgowenlock · 25 Sep 2007 at 19:29

Is this all new OcUK kit?

I just bought E6600, Geil RAM and Gigabyte DS3R mobo and had exactly the same problem. RMA'd the board but havn't had it back yet, have you tried different RAM?

cam · 25 Sep 2007 at 22:50

had it for a bit, like 4-6 months, isn't ram problem i don't think. Doesn't beep when removed.

xirokx · 25 Sep 2007 at 23:24

tried resetting the cmos? made sure all connections are secure? triple check the power connections?

cam · 25 Sep 2007 at 23:43

resetting cmos?

everything else has been checked

xirokx · 25 Sep 2007 at 23:47

changing the jumper settings on the mobo for a few seconds its fairly simple and will in the mobo manual...

sorry to ask but are you sure your monitor is working? have u tried an alternative monitor?

thefishdude · 25 Sep 2007 at 23:49

4 pin power connecter plugged in ? easily forgotten.

also can you get to bios ?? what voltage does the ram require? i know there used to be problem with default voltages not enough for ram to kick in when it was fancy ram and not cheap value. used to stop pcs booting. dont know if they sorted that problem now thogh this was about year ago when frst c2d boards were out

cam · 25 Sep 2007 at 23:58

yeah, tried many of monitors.

doesn't allow me to get to bios. It isn't a new setup, just randomly did this one morning ;(