First WC finally finish!

Oh dear one thing after a bloody another with this thing. It came up with startup repair, something about hard disk. Then would just hang at the windows logo, then got pass the window logo and blued screened what a joke. No idea what's happened the ssd is only a few months old :(
 
Last edited:
fantasticCG said:
Oh dear one thing after a bloody another with this thing. It came up with startup repair, something about hard disk. Then would just hang at the windows logo, then got pass the window logo and blued screened what a joke. No idea what's happened the ssd is only a few months old :(
Click to expand...

Maybe corrupt installation - try booting and reinstalling off Windows disc

Had this with my friends comp, just chucked windows onto his mechanical hdd and re-installed flight sim onto the SSD.
 
CSMonkeh said:
Maybe corrupt installation - try booting and reinstalling off Windows disc

Had this with my friends comp, just chucked windows onto his mechanical hdd and re-installed flight sim onto the SSD.
Click to expand...


Sorry that your having probs m8,if you haven't reinstalled yet .

Try using the upgrade option as this will save you reinstalling everything and save you lots of time in the process ' hope you can sort this quick.
 
The upgrade option? That's on the windows disc? 2weeks and still no computer :)
When I first turned it on I'm sure I had to press f something, cant remember exactly. Start up repair couldn't fix it. Now I just a black screen with a little flashing white line in the top left corner. Everything seemed fine In the bios. Hope I don't have to buy a another ssd. It's only 3 months old I'm guessing I can return to oc's. I unplugged the other 2 hdd as nothing seemed to happen when all 3 where plugged in.
 
If it will let you reinstall,press the upgrade option instead.
Basically it reinstalls everything but keeps all your otherstuff intact(files,settings etc)
 
This comes up when I go to install windows as the upgrade wouldn't work.

Windows cannot be. Installed to this disk. The selected disk has an mbr partition table. On Efi systems, windows can only be installed to gpt disks.

What does that mean?

Fixed it. Change the boot option
 
Last edited:
Ideally a T-line and a ball valve, I just un-couple my QDC's and separate the barb and drain from there - its not ideal.

As for your install problems, did you perform a full format on the hard disk, and AHCI enabled?
 
I have formatted the disk windows started to install got to like 80 percent then the screen went black. Tried using the windows disk again was just on the setup screen for ages then the screen went black again. Ahci is enabled it shows it when I boot up the pc
 
Not entirely sure what that would achieve unless the PSU wasn't up to powering two 680's?

Can you dump the disk image and try install from USB?
 
Could someone check my loop order please. Res/pump out port into the 360> into the CPU outlet port. CPU inlet into the 120 >120 into the graphics card>240> 240 into the res/pump inlet port
 
Is it possible it could be overheating and shutting down? if your not in windows then the CPU won't throttle as much so temps will be higher than normal idle, and im not sure what the GFX cards will do with no drivers.

Have you tried swapping the tubes on the CPU round so it isn't going in the outlet and out the inlet? Im not sure what difference it makes but EK do put a bolded warning about it in the CPU block instructions.
 
It looks like the the card is failing as I had only the top one plugged in. Apart from swapping the CPU ports round is the rest fine??? I think your right though they need to be swapped over. I'll have to wait until next week now as I missed
The delivery people today with the New tubing.
 
You must log in or register to reply here.
Back
Top Bottom