Help please recommend setup

Need the ambient temps as well tbh so to see what the delta is. It's been damn hot this last week.

Been at the bottom may be restricting some air flow due to space from bottom of case to table/desk top

Are the fans pulling the air or pushing ? Looks like pushing from the pick. Try the other way, I know its putting heat into your case. Try it to see if pulling air from outside helps
 
Need the ambient temps as well tbh so to see what the delta is. It's been damn hot this last week.

Been at the bottom may be restricting some air flow due to space from bottom of case to table/desk top

Are the fans pulling the air or pushing ? Looks like pushing from the pick. Try the other way, I know its putting heat into your case. Try it to see if pulling air from outside helps

thanks for the advice appreciate :) so ambient temps around 26 idle temp 31 tonight i hit 64c under load the radiator was roasting and heating bottom of case. Ill flip the fans around and add 2 120s i have spare under radiator as well to push. Ill report back in a few hours once done and tested ....
 
Last edited:
ok so just to report back changed fans from push on top of radiator to push pull see picture , peak tempreture is still 65c. The radiator feels hot to touch :-

6gj1n6.jpg

65c seems to hot to me and is not that far of from stock cooler , i dont know if i should grab a 420 or 480 radiator add to loop or rebuild loop and remove this 240 rad as it does not seem to be able to cope with load. Advice appreciated please
 
Last edited:
Do you know what the water temp is?

Try the rad at the top.

Sounds daft but you have the fan orientation correct for the bottom fans on the rad? So there not working against each other.

Not sure what other peoples TX's do on water. Need one to comment. ( hint hint )

If you are going to add the cpu anyway you might as well grab another rad. A 4xx + a 280 should be more than ample

Had CPU + a 290x on one 360 with no issues until my custom build when I went for 2.
 
Back
Top Bottom