Issue?

corleone Vito · 1 Oct 2011 at 20:50

Help!? I put a usb into my new build - it wasn't reconising also it has malfunctioned my usb!? FYI i put it into my motherboard USB 2.0 port also my drivers hasn't yet been installed!!

bobbarley · 1 Oct 2011 at 20:51

What???

corleone Vito · 1 Oct 2011 at 20:59

Ok... i built a new PC right - i put the drivers onto a USB to install into my new unit and it fried my USB and now when i put it into my current PC it says it malfunctioned......

bobbarley · 1 Oct 2011 at 21:00

Does it say that it can't read the USB drive?

corleone Vito · 1 Oct 2011 at 21:14

Nope, but the USB got extremely hot - the light indicator on the usb show it active never appeared and know when i plug my usb into my current pc i am using which i transfered the drivers it says " please consult with your device manufacturers for assistance getting this drive installed" because it failed...?

GTO656 · 2 Oct 2011 at 00:06

have you tried it on another PC or formatted it? it not it probably has died unfortunately.

corleone Vito · 2 Oct 2011 at 09:22

I have tried it in my brother laptop and my PC both not responding...

95thrifles · 2 Oct 2011 at 09:29

I would guess your USB stick has died, buy a new one

corleone Vito · 2 Oct 2011 at 09:30

I know my USB stick has died, but i just want to know will my new build short out every USB stick ill put into the unit?

corleone Vito · 2 Oct 2011 at 09:31

if it does, how can i resolve it?

95thrifles · 2 Oct 2011 at 10:22

dont know, it could be the build, or it could have just been the stick, you wont know til you try another, if that dies then its the build, if it doesnt then it was the stick
depending on the mobo/bios you may be able to manually adjust (lower) the USB voltage in the BIOS if it is an issue