Jonsbo VR3 Mini-ITX PC Case – with PCIe 4.0 Riser Cable

Associate
OP
Joined
25 Jan 2006
Posts
2,057
Location
Kent ,UK
Any test data? I'm not sure I want to build in this case, after all, given that [Jonsbo told me that I should return it]. (Your data could reassure me that I should keep it.) Thanks!
My room temp was 30.3c ,

I tried a good Top down CPU air cooler Big Shuriken 3 Scythe with 2 x 120mm fans on front blowing out & temps was really Toasty, Motherboard/system temp 68c .

so AIO way to go like the Corsair Hydro Series iCUE H100i Elite CAPELLIX 30mm thickness.

NOTE: My Arctic Liquid II 240MM AIO really hard to install due to the 38mm thickness of the rad.

Installing a GPU like 3070 ti /3080 3090 Going to push case Temps up a lot. But are fine under load around 66c AMD 6800 & Tested the 3070TI gamerock 3 slot card Temps reached 76c.

basically it come down to the components you install = outcome on Temps.
 
Last edited:
Associate
OP
Joined
25 Jan 2006
Posts
2,057
Location
Kent ,UK
Here you go, AMD REF-6800

Room Temp 25.1C
1UotoRY.jpg.png

144Hz Enabled
ypqKbxm.png

CEdUnT3.jpg.png

Desktop Idle Temp
dbQQIND.png


Heaven benchmark 4.0 Under load - Score 4500
WY0nJmX.jpg.png
-------------------------------------------------------------
AMD built in stress Test

zBbELnh.jpg.png

M0syM8s.jpg.png
Running the stress test for 60s
 
Associate
OP
Joined
25 Jan 2006
Posts
2,057
Location
Kent ,UK
I did a quick benchmark of the Front / Top I/O USB 3.1 Type C port
Crucial x6 2tb portable SSD storage

Using the top case Type C very Poor performance due to using the 19/20 pin USB 3.0 port
n4ZfCd4.png

Using a proper Type C 10GB from back of Motherboard or GPU
This is the max read & write spec of the Storage Spot on
T2J68iS.png
 
Associate
Joined
12 Aug 2022
Posts
16
Location
United States of Leprechaunica
Thanks! I received the case, installed my hardware, and found comparable temperatures--best I've seen of the RX 6800, of the cases I've had it in (NR200, H210, and the VR3). A non-issue, thus. My guess is that a few choice GPUs struggle in top-I/O configuration and that a game of telephone or two turned it into a major crisis. (Such is PC life.)
 
Associate
Joined
19 Nov 2022
Posts
1
Location
Manchester
Hi,

Just looking to buy this Jansboo VR3 case and Arctic Freezer 280 AIO cooler? would you say it would be to tight and should pick something with thinner radiator? Any recommendations? Still thinking if I should go with Intel or AMD for a CPU (ITX MOBOs for AM5 seem to be super expensive still). Maybe EK Water Blocks EK-AIO 280 D-RGB (£119) or Kraken X63 RGB (£135) or Corsair iCUE H115i PRO XT RGB (£115)?
 
Last edited:
Back
Top Bottom