Lian Li PC-011 WGX ROG v2

Also, @ChugNorris or any Asus Formula owners.
Is it possible to measure the distance vertically (centre to centre) between the lower inlet port on the Formula board to the inlet port on a EKWB CPU block (if the block is mounted horizontally)?
I’m trying to work out if it will align with the EKWB distro plate I have got for this case.
Thanks in advance to anybody how replies, without these forums I don’t know how I would get half the information I have needed to plan this build.
 
hiroofheroes said:
http://www.lian-li.com/o11dxl-2

SSI EEB needs the bracket. Same as the dominus it would block the side intake.
Click to expand...
Looks like your correct, it has the EEB mounting holes on there.

the dominus is just oversized an extra inch width wise and two inches height wise. The extra space doesn’t use any extra mounting holes... I would seriously put some spacers there, don’t want to be flexing a £1500 board.
 
I am planning a new build and was going to get the Lian-Li PC-011 Dynamic but taking some advice from fellow forum members I am noe leaning towards the XL version.

My aim is to mount a vertical GPU in the case, but still have room underneath the GPU to mount floor fans etc.
With the normal Dynamic case this was not possible with the Lian Li gpu bracket as it looks like it bolts to the bottom case cover, so the work around was a cool master bracket.-
https://forums.overclockers.co.uk/t...performance-contender-arrives.18817302/page-9

https://www.overclockers.co.uk/cool...ertical-gpu-holder-riser-cable-ca-36l-cm.html

With the XL case, the Vertical Gpu bracket is different and means a rad/fan set up is ok.
http://www.lian-li.com/o11dxl-1/


My question here is, has anyone used the Lian Li bracket in their build or the Coolmaster equivalent and if so what are you thoughts.

Thanks
 
You must log in or register to reply here.
Back
Top Bottom