Loop and questions

Jig saw, circular saw, nail guns!, router, various drills, chop saw, 12" disc cutter, 4" grinder.

And to clarify the front pillars either side of case. Want to put led strips in there, but the slit needs to be thin.
 
Last edited:
question
installing my D5 with aquabus pump into koolance cov.v2 top/res
there is a star shaped plate which you place on top of the pump before screwing top down, but on my pump there is the interface connections so i cannot use it :( i have cut it up and its in but i dont trust it as its in 3 pieces and they could possibly shift when running and that could spell disaster. so basically a need a big washer of some sort to get round this same sized circumfrence of pump and about 8mm wide and 3-4mm think, any ideas??
 
With my pump/res being low in my system should i fill via my top rad, or should i stick to res fill. My bottom rad has been flipped connections now at the top and not the bottom.
 
You must log in or register to reply here.
Back
Top Bottom