mals 'more than I can chew?' mod

Well, I personally like the smooth minimalist look. So I would lean toward power and reset buttons on the left hand side edge of the fascia and usb/audio/firewire on the right so they arent visible on the front of the case.

(sorry for the dodgy paint images, had i been at work i would have used Co-Create :p)
Its difficult to envisage the vented panels with these drawings which dont show the perforations.

base%20minimalist.bmp


On the other hand, I could go with white power and hdd LEDS and silver buttons to match the silver paint areas.

base%20silver%20white.bmp


However, a little voice is calling to me and its saying 'pimp it, pimp it'. In which case, I would use the latter but use coloured LEDS, red and or blue CCFLs behind the vents (i have two of each lying around), and some LED effects or a LCD across between the floppy and lower vent.......
 
Cheers Pulse.
No construction has taken place since my last post, but I am hoping to get back to it this week :D

I do, however, have a question.
How accurate are the AMD on die temperature sensors?
Or, does the motherboard make calculations based on what the on-die sensor reports?
 
Yeah, I know how it goes, I was just curious as to whether or not they are accurate and if the motherboard was processing the reports.

If they are that accurate one is amused. I just ran OCCT overnight to test the cpu temps and they never rose above 34c loaded :cool:
 
You must log in or register to reply here.
Back
Top Bottom