new system, what a difference

Soldato
Joined
4 Nov 2004
Posts
3,040
Location
Norn' Iron'
just installed HL2 and what a difference i see over my old system:

3200 barton
1gb pc3200
6800nu

HL2 runs sweet as a nut with everything maxed out for ultimate eye candy!

sig is in spec
 
DaveyD said:
It is nice to run everything on high and smoothly :) even if it's a 2 year old game :p

isnt half, just have to get FEAR extraction point to run in widescreen mode now, real PITA, FEAR will run in 1440x900 no problem but i can seem to get FEAR EP to run in the same res :S any ideas, ive tried widescreen gaming forum and stil no joy!
 
DirtyJester said:
:) Never even noticed you were from ere as well m8 ... nice one !

where bouts you from?

Zefan said:
New system!?

We all know you're using that bodged 5700 ;)

shhh, thats between me an you! ;)

the time will come when i will 'bodge' the 7900 with a AC freezer lol... hmm i wonder what temps i will get with that combo :eek:
 
Nice one :) , i went from a 1.7 celron, 256mb ram, onboard gfx 32mb to 3200+ winny, 1gb ram, 6800GT a couple of years ago and was gobsmacked. The only games i could play before i upgraded was rogue spear :cool: and SOF2 (just) so when i first saw far cry and hl2 i did a small sex wee :D .
 
Thats almost the exact same upgrade that i did,

A64 3500+ (default 2400Mhz)
2gb G'skill (good ram! shame i had tio sell it)
6800ultra.

to

e6300 @ 3100<hz
2gb Geil DDR 7 x 443
7900GTO 710mhz gpu (1550 ddr).

.....oh whoops, when checking these setting it appears my pc bios has reset as i'm back at default and i hadn't even noticed any differance!

Edit: thats better! Strangly my bios hadn't reset but the memory overclock setting was disabled.... did see this in the bios though but aparently from what i can get from google it happends when you go above the normal Ram voltage than specified... even though i had to for this ram as it's rated higher.
bios1.jpg
 
Last edited:
hardc0re_tid said:
been there, done that, doesnt work (for me anyway) will have a go again later on though

works for FEAR but not for FEAR extraction point :( dont know why though they use the same engine AFAIK

Have you tried setting the file to read only? I believe you have to do that in FEAR Combat otherwise it resets itself on startup :)

Similar upgrade to me.. went from a xp 2800+, 1GB, 9800pro to below. It's amazing being able to play source games and actually control where I'm going...
 
Back
Top Bottom