O11 AIR MINI, will it hold full ATX, 280MM Rad and veritcally mounted 4080?

So.. turns out, I could make it fit.





To do this, I added spacers to mount one side and then use the offset brackers plus spacers to mount the other side. The rad is as far forwards as possible, and it *just* has enough space for one 140mm fan on it. Because of the full ATX board I have in there, there's no way I can get the second 140mm fan on it. I'm going use a 3D printed plate to mount the 120mm fan offset on the 140mm mount.





I've not fully stressed it yet, and it might make sense to horizontally mounted the 4080 - but I'll see how it goes.
 
If using an ATX board it will only support a 280 at the bottom, you just have to be careful about the radiator thickness, fans are 25mm, so nothing more than 30mm rad thickness if you are using the vertical GPU mount otherwise it wont fit.

If you're using an mATX board for instance, you can change the configuration of the case and put the rad in the top quite easily.

Im using an mATX board, but kept it in the ATX config, makes it easier if I decide to go back to an ATX board, this is 280 in the bottom and 120 on the side with the FLT120:

13UOjk9.jpg
 
Does no one read threads anymore? I fitted the 280mm rad at the top

It supports a 280mm at the front, just not with a 4080. It was fine with the 7900 XTX
 
Last edited:
GeX said:
Does no one read threads anymore? I fitted the 280mm rad at the top

It supports a 280mm at the front, just not with a 4080. It was fine with the 7900 XTX
Click to expand...

Yes I did see all of that, but you had to mod it to fit it at the top.

What was wrong with putting it at the bottom, look at all that space you have under the vertical GPU mount

EDIT: Cancel that, its an AIO, not good for routing tubes.
 
Last edited:
You must log in or register to reply here.
Back
Top Bottom