Phanteks Enthoo EVOLV.

Looks great but that tinted window is bad and not clear at all even with led's behind it.

They should offer clear replacement windows.
 
Totally agree. I do hope they offer a clear option at some point. I did take the panel out with a view to getting my own cut (used to work in glazing.) However, the machined bezel that allows the window to sit flush on the panel would make it prohibitively expensive as a one off.

The only other option being a flat piece with some sort of thin rubber/plastic strip around the hole in the panel:(
 
Seeiously tempted to get the ITX version and mod it for my mATX board. Preordering has just come up for £50 and £55 for non-windowed and windowed versions. Looks like the PSU is set to the right side (away from the mobo) a bit. If I cut a space for the board to go down a bit next to the PSU it looks like it'd fit. Anyone who has seen the case or know of vids/review sites with lots of images close up?
 
Ok, it's ordered. I replaced the RAM for the 256gb Crucial MX100 as my games drive is a tad small! Hope I've made the right choice!
 
Looks fine. I've chose same fan to replace the rear exhaust in mine.

I've got 6 of the 120mm version of which 4 will be used in push/pull on my H100i.

EDIT

Went with this in the end, that's my weekend sorted :)

YOUR BASKET
1 x Phanteks Enthoo Evolv Micro ATX Case - Black £89.99
1 x Crucial MX100 256GB SATA 2.5” 7mm SSD + 9.5mm Adapter (CT256MX100SSD1) £79.98
1 x Alpenföhn 140mm Wing Boost 2 Plus PWM Fan - Red £9.95
Total : £179.92 (includes shipping : ).

 
Last edited:
Seeiously tempted to get the ITX version and mod it for my mATX board. Preordering has just come up for £50 and £55 for non-windowed and windowed versions. Looks like the PSU is set to the right side (away from the mobo) a bit. If I cut a space for the board to go down a bit next to the PSU it looks like it'd fit. Anyone who has seen the case or know of vids/review sites with lots of images close up?

get the Matx case. The ITX uses some plastic to keep the cost down.
 
Ok, all setup and partially working, but the PWM hub is pretty poor. The only fan running is the front 200mm, all the other fans, including the 4 on my H100i are off and pulsating like the power can't be provided!

Anyone else had this?

I think I'm going to revert back to fan splitters, but they look so messy!
 
What I mean is have you plugged a sata power from your PSU into it (the fan hub)

yeah I have and it only seems to work off the CPU header, which is ****, so I've disconnected it entirely and using 2 mobo headers for the case fans - PWM is working just fine this way, not sure why the PWM hub can't.

Anyway - sorry for the bad pic, room isn't well lit:

35d3yiu.jpg


All I can say is wow - what a case. It's stunning, well built and has plenty of space allowing for a clean looking build :) Well happy :D
 
Back
Top Bottom