Post your antec 300 lad's ;)

after installing my 9450 and new cooler
IMG_0151.jpg


IMG_0150.jpg


and the previous incarnation
DSC00052.jpg

DSC00053.jpg

DSC00054.jpg

DSC00062.jpg

DSC00063.jpg
 
Excuse the carp phone pics.

MATX board is temporary till my Asus board returns from the land of RMA.

Cable managment is terrible I know, I need to get a modular PSU and sort it out, no Hdd bays makes this a difficult task was much neater before I went down the water route.

jrrat2.jpg
 
I was planning to drop my dvdrw down, and mount the triple rad at the top inside...

Then install my HDD under the dvdrw, remove the hdd cage sides and install my res and pump there
 
Thanks!

I got my case powder coated inside & out matte black.

Yep, I used a 25mm bi-metal hole saw and then used grommets to line the hole.

Cheers
 
The latest pic of inside my case, hard to take as its under my desk and a bit of a squeeze
17122010055.jpg

modded front
DSCF2768.jpg

Before i moved house so now under desk.
DSCF2762.jpg
 
Although I am pretty sure I could make a 120.3 rad fit in the top of my 300, I have decided to go with mounting the radiator externally on top.

I have some ideas in my head how it will look, and plan to start modding my case again when my radiator arrives.

Can't wait :D
 
This must be the hundreth time of posting this pic, but I'm going to post anyway. :P

IMGP2330.jpg


I chopped down the 5.25" blanking plate so it's flat, then stuck it to the optical drive to hide it, removed the HDD bays, suspended the HDDs reverse mounted in the empty 5.25" bays to hide the cables, chopped loads of holes in it, and used the casing from an old PSU to create a cable hide box thingy. It also has Xigmatek White LED fans, 2x120 in the front and 1x140 in the roof. (They look orange).
 
Last edited:
Back
Top Bottom