Problems Booting...

Associate
Joined
4 Jun 2007
Posts
2,280
Location
South Wales
Just built a new rig:-
Motherboard - AsRock ALiveNF6G-DVI
CPU - AMD Athlon 64 X2 4800+ Skt AM2
RAM - VData DDRII 667MHz 2GB
Graphics - Xpert Vision NVidia 8500GT 512MB
Maxtor DiamondMax 250GB SATA2
1 x DVD-rom
1 x DVD RW
700W PSU

Just tried starting up and it doesn't even run the memory check, not even giving beep beep codes...HELP!!!!!
 
Last edited:
Man of Honour
Joined
17 Feb 2003
Posts
29,636
Location
Chelmsford
I've looked at the guide and the 4 pin is not crucia anyway..

Ok, Do you have the internal audio speakers connected correctly? Just make sure becuase if the POST is failing, you should get thoese bleeps.

Are you able to enter the BIOS at all?
 
Man of Honour
Joined
17 Feb 2003
Posts
29,636
Location
Chelmsford
Ok, it might seem obvious, but it does happen, check that your monitor is working and is connected correctly. Check that the cable is ok.

Did you buy the Mobo new or second hand? Try reseting the CMOS by locating and placing the CMOS reset jumper to reset. Then try again.
 
Associate
OP
Joined
4 Jun 2007
Posts
2,280
Location
South Wales
just checked monitor on brothers pc and wrkking fine, resetting cmos was one of the first things i tried, sorry should have sed lol, bought it new off a certain 4 letter named website, sold as new anyway....

[edit: bought as a mobo, cpu and ram bundle]
 
Man of Honour
Joined
17 Feb 2003
Posts
29,636
Location
Chelmsford
Ok, givent the fact that it's not POSTing, but you have power to the fan, then it's either the PSU or Mobo but proving either maybe a bit difficult.

THe first thing you can try is test the PSU using a mutli meter, see if you can get your hands on one and here's how:

Firstly, remember that the Yellow cable supplies +12v, the red +5v, and the black is ground.

Turn PC off but leave plug connected.

Take power connector (Molex) and insert black probe into black wire connector.

Insert red probe into red wire connector.

Set multi-meter to 20volts and turn on PC.

Read out should be around +5volts.

Turn off PC and repeat process but this time connecting the red probe into the yellow wire.

Power PC on again and read the read out should give you around +12volts

Allow for some deviation of around 5% either side of the expect rails. So for 5volts you need to allow between +4.8volts and +5.3volts and for 12volts between 11.4volts and +12.6volts.

Anything outside this range is certain to be a problem with the power supply.
 
Back
Top Bottom