Soldato
seems cheap for bitspower 
Project: Temjin-S
- Thread starter Cleeecooo
- Start date
probably spent more though.
Waiting for more money until i order sleeving and spraypaints and more bitspower love!!!
Waiting for more money until i order sleeving and spraypaints and more bitspower love!!!
Soldato
you flushed the rad and blocks yet?
not yet. Testing the pump for an hour or so first. I'll flush everything out later whilst spraying it all
Soldato
cool
What am I supposed to flush with?
Soldato
de-ionised water/purified water, if you don't have enough then flush it a couple of times with tap water, then once with the de-ionised/distilled
yeah, i'm using tap water ATM. I'll do a final flush with de ionised
Caporegime
Good to know you're not dead Cleeecooo!
Caporegime
you never know, I hear EVGA have been making self destructing 580's
I was more on about the rioters
Soldato
hows the leak testing going?
hows the leak testing going?
perfectly
Sitting on the top of my computer now.
These bitspower fittings look soooo good! I need to get some more...
Soldato
want some too
need some more 45's and compressions.
Soldato
I want 90 degree fittings and normal ones
Soldato
just wanted to point out, this thread has been taken over by you two 
what happened to the general chit-chat being kept on the other thread.
what happened to the general chit-chat being kept on the other thread.
UPDATES AT LAST!!!!!
Well i'm £4 short of sleeving so I guess it will have to wait - again!
However, I've setup a loop outside my comp to test fro leaks and to flush the rad and try to clean some of the grime out from all my second hand bits :/
I am not using any of the new stuff (apart from rad an fittings) but here's the loop:
When the sleeving arrives, i'll take everything out of the case, start doing all the mods i'll need to do and I will also liquid cool everything when it is out of the case. Then, I will do the liquid cooling properly in the case when it comes back from the powdercoaters
Well i'm £4 short of sleeving so I guess it will have to wait - again!
However, I've setup a loop outside my comp to test fro leaks and to flush the rad and try to clean some of the grime out from all my second hand bits :/
I am not using any of the new stuff (apart from rad an fittings) but here's the loop:
When the sleeving arrives, i'll take everything out of the case, start doing all the mods i'll need to do and I will also liquid cool everything when it is out of the case. Then, I will do the liquid cooling properly in the case when it comes back from the powdercoaters
Soldato
why did you use so much tubing, having the pump down there?