• Notice regarding image hosts and attachments. See here.

Road Cycling Essentials

Status
Not open for further replies.
I wear bib shorts for all my road or XC riding, then depending on conditions just alter between thermal tights, thin tights, knee warmers or baggy shorts over them.

Looks like a good time on the KK George.
 
Decided to treat myself to a little something for every milestone I hit with regards to my weight loss, I've just comfortably got into the 17 stone bracket which means my weight will never again fluctuate into the 18 stone something, so for that I've treated myself to a set proper set of cycling shoes / pedals.

When I'm in the 16 stone bracket it will be another something, perhaps a decent helmet or some sort of clothing and when I finally make it into the 15's it will be a new bike.

I went with the wide fit Shimano R087 shoes and Shimano 105 black pedals, looking forward to decent contact and more efficient cycling!

For those that don't follow the "Weight Loss" thread heres what I've managed so far,

http://forums.overclockers.co.uk/showpost.php?p=21291626&postcount=383
 
Get the bike first tbh.
It will help you to lose weight and, assuming you've stopped growing, it will always fit you. At the rate that you're losing weight, any expensive clothes you buy wont last long before they are too big.
 
I just wear overshoes which keep my feet toasty and double base layers with a jersey for the top half.
I did 67 miles today and was very comfortable.

You didn't cycle past the Edstone aqueduct yesterday by any chance did you? I've just looked at the road bike in your sig and it looked very much like a bike I saw heading away from Stratford.
 
Get the bike first tbh.
It will help you to lose weight and, assuming you've stopped growing, it will always fit you. At the rate that you're losing weight, any expensive clothes you buy wont last long before they are too big.

I can't quite afford the bike yet and also I don't want to run the risk of being too heavy for the wheels, I'll have it by the end of May though.

The helmet will always fit and clothes will be lycra based so have stretch in them :)
 
Sorry, should have clarified by saying base layer clothing, stuff that's going to be snug fitting regarldess of my weight, if you see the pictures I posted above you'll see how broad my shoulders are in relation to my waist, I'll always need to wear an XL-XXL shirt regardless of how small my gut gets.

Has anyone here got the Giro Ionos helmet? Looks brilliant and I think it's my next treat for my next milestone.
 
Well done to the KK riders! Looks like a tough ride, I doubt I'd have done it without getting off!

Instead I did my first club ride on Saturday morning while it was raining hard enough for the rivers to burst their banks here in the Ribble Valley. Some nice inclines and fast sections. We didn't particularly push it all the way but the ride, including me riding to the meeting point and back was 45 miles over 2h 40mins.

I did however discover that my brake pads are toast after a 40mph descent towards a hairpin bend. The torrents of rain didn't help matters but I'm still alive and managed to scrub some speed off! I suppose the pads have lasted 2 years now, haha. Probably about time I cleaned the bike and had it serviced.
 
Morning mate.

Lower back and between shoulders very sore. Took today off, so just relaxing ATM :)
I think you're entitled to a day off after that amount of effort. You should be pleased with that time! Hopefully you'll beat it next year ;)

After all that, my tyre was flat again this morning :mad:
You should have checked to make sure there's no debris in the tyre before putting it back on :P

I've spent the past three weekends studying for an exam I have on Friday (configuring Active Directory in Windows Server 2008, in case anybody's interested :P), haven't been for a proper ride in all that time. The weather forecast for this weekend looks favourable though, so hopefully I'll be making up for lost time on Sunday :)
 
Terrible ride to work today in the wind and rain. Average speed? 12.5mph :)

Not on a bike over a month, I think, was hungry and my chain is skipping on my favourite gears.

Lets hope I can get some sort of fitness back.
 
You should have checked to make sure there's no debris in the tyre before putting it back on :P
I thought I'd got all of it, there were SO many little shards of glassy stuff stuck in the tread it was unreal. I'd already given the tyre a check and a clean up the night before. I reckon I just got unlucky again and picked up another bit on the way back :(
 
Absolutely gutted right now. I took my stem apart one last time just to make sure all was well and, after reading a few horror stories about carbon steerers, to give it a good checkover for signs of stress.

It looks like sadly i was right, riding around on it constantly with a loose headset (and not realizing) had taken its toll. There was a noticeable mark on the front of the steerer which i assume was from the stem moving up and down as it worked loose. On the inside of the steerer more alarmingly was rather deep scoring, i think this was caused by the bung in the steerer for preloading the headset had worked itself loose the first time (when i didn't realize the stem wasn't gripping properly and went for a long ride when i'd only had the bike for a week) and when i went over a pothole it pulled the bung out a few mm.

To be fair the guy in Halfords said he was 90% certain it was a warranty job (to which i replied i'd hope so with it being a £1k bike thats 3 months old). Though worryingly he said this while putting the headset back together without the use of a torque wrench :/

Just going to have to wait and see.
 
Rushed home from work today and managed to get my first evening ride of the year.
A quick 12 miles with a nice wee 200m climb in the middle.
Windy but fairly warm. Its nice to get out in the evening again. I think i'll get into work a bit earlier tomorrow and give myself a bit more time on the bike.
http://connect.garmin.com/activity/151196182
 
Absolutely gutted right now. I took my stem apart one last time just to make sure all was well and, after reading a few horror stories about carbon steerers, to give it a good checkover for signs of stress.

It looks like sadly i was right, riding around on it constantly with a loose headset (and not realizing) had taken its toll. There was a noticeable mark on the front of the steerer which i assume was from the stem moving up and down as it worked loose. On the inside of the steerer more alarmingly was rather deep scoring, i think this was caused by the bung in the steerer for preloading the headset had worked itself loose the first time (when i didn't realize the stem wasn't gripping properly and went for a long ride when i'd only had the bike for a week) and when i went over a pothole it pulled the bung out a few mm.

To be fair the guy in Halfords said he was 90% certain it was a warranty job (to which i replied i'd hope so with it being a £1k bike thats 3 months old). Though worryingly he said this while putting the headset back together without the use of a torque wrench :/

Just going to have to wait and see.

Gutted mate.Hope they sort it out for you quickly and as pain free as possible.

They could argue you fannied about with it to be stubborn but they would have to be really awkward.

Torque wrenches aren'y everything...I've seen stem bolts break getting torqued to spec. I do mine by hand to be frank but on other bikes I'll use a torque wrench.
 
Had to take my bike into the shop again at the weekend, I've started to have problems with the rear wheel since snapping the spoke just over a week ago.

I had the broken spoke replaced and the whole wheel tightened up etc, I rode about 50 miles on it and then 4 or 5 spokes had all loosened up and lost all tension in them.

I bought a spoke key whilst at the shop so I can tighten them up myself if they come loose again and I've read a few guides on how to do so but I'm curious as to whether this is something that is down to not being sorted properly by the shop or something wrong with the wheel?

Also another quick question, does anyone here own a Giro Ionos helmet or know anyone with one? Are they any good? I think they look brilliant and I've been happy with all my other Giro helmets but it's a fair bit of money for a helmet!
 
I bought a spoke key whilst at the shop so I can tighten them up myself if they come loose again and I've read a few guides on how to do so but I'm curious as to whether this is something that is down to not being sorted properly by the shop or something wrong with the wheel?

A properly tensioned and true wheel should stay tensioned and true. I had similar issues with the workshop monkeys at the Edinburgh Cycles, they had my bike back four times. In the end I bought a spoke key and read up on how to do it properly. Never had a problem since! It's not hard to do but don't rush it.
 
Status
Not open for further replies.
Back
Top Bottom