Soldato
- Joined
- 23 Nov 2004
- Posts
- 10,646
If it did it before then yes.
Set the tension in the smallest cog on the back. Make sure you click on the upshift paddle all the way, not just when the chain drops into it.
Wind barrel adjuster fully in then wind it out a turn. Undo cable clamp, pull it tight sometimes through the wheel is easier if it's a shadow mech. Check it's tight enough by shifting down a gear, if it goes then check the next two down shifts. In the 3rd or 4th cog from the bottom that is where I'd adjust the barrel adjuster if it isn't quite sitting in the gear. Turn it the direction you want the chain to go.
Set the tension in the smallest cog on the back. Make sure you click on the upshift paddle all the way, not just when the chain drops into it.
Wind barrel adjuster fully in then wind it out a turn. Undo cable clamp, pull it tight sometimes through the wheel is easier if it's a shadow mech. Check it's tight enough by shifting down a gear, if it goes then check the next two down shifts. In the 3rd or 4th cog from the bottom that is where I'd adjust the barrel adjuster if it isn't quite sitting in the gear. Turn it the direction you want the chain to go.