Halz i'm not exactly closing the gap on you am i, cant seem tolessen the gap to less than 70000 although my output is improving.
Think it might be time to see what i can pull out of reserve
Tried overclocking?
Halz i'm not exactly closing the gap on you am i, cant seem tolessen the gap to less than 70000 although my output is improving.
Think it might be time to see what i can pull out of reserve
Think it might be time to see what i can pull out of reserve
Tried overclocking?
If I'm pushed I will respond
Look at the picture of mine, whats important is that distance between the bottom slot and the PSU. GX2's are "sandwiched" dual slot cards with beefy coolers, even when you watercool them because the cards themselves are two cards sandwiched together they still take up a fair bit of space.
Anything that has a more than average space between the bottom slot and the PSU would be ok probably. Otherwise you are looking at cases with the PSU at the top. but even then you can get caught out if going for too small a case.
I was curious about a case + mobo that would hold 4 gpu's in the end i phoned ocuk and they suggested the corsair obsidian 800d and Evga board and said they would go together ok, like biffa said though it would be a very fine fit for the bottom gpu especially if you were going to watercool....allas i plumbed for another setup...credit card said no
do you know.... I am having most troubles fitting even 2 graphics cards into a single case! But then most of my builds are mATX.....
Im looking out for a case that will 'eventually' be a nice toasty home for 4 x GPU's - probably 9800GX2's. Im not quite ready to buy yet, but I thought if I can nail down which ones I want, then I can keep an eye out in MM for a 2nd hand one, or buy one here if none come up
They key bit is getting a case that has the expansion slots for all 4 GPU's but Im hoping to avoid a full tower if possible, though Im not sure how likely that will be. Im not bothered about looks or noise as it will be getting lots of extra fans and be under a desk in a test room at work. This rig will be purely for crunching to keep Grimgoth, Toxic, Halz and all the other young upstarts at bay. It will be useful in my efforts to well and truly stomp Dougiebabe2003 (GrandMasterD)....
Models Im thinking about are
CoolerMaster CM-690
http://www.overclockers.co.uk/showproduct.php?prodid=CA-177-CM&groupid=701&catid=7&subcat=29
CoolerMaster HAF 922
http://www.overclockers.co.uk/showproduct.php?prodid=CA-176-CM&groupid=701&catid=7&subcat=29
Lian Li BC-B25F
http://www.overclockers.co.uk/showproduct.php?prodid=CA-183-LL&groupid=701&catid=7&subcat=187
I know these cases will hold 3 gfx cards, but will they hold 4???
Biffa - I know you have some experience on this one - what cases have you looked at, I know you are using a Lian-Li A70B, but that is a full tower and more than I would ideally like to pay, though 2nd hand might be a bit cheaper...
Open to suggestions, though Im going to have a good look around this weekend...
Just for a bit of fun I beat the following on seti classic - you may recognize some names .......