****Show Us The inside of your Case!****

this is my new case coolermaster 430 tried my best with wire managment. so about pics im not a picture taking person
DSC01636.jpg
[/IMG]
DSC01634.jpg
[/IMG]
DSC01632.jpg
[/IMG]
DSC01631.jpg
[/IMG]
DSC01630.jpg
[/IMG]
DSC01629.jpg

DSC01628.jpg
 
Last edited:
Your PSU appears to be mounted upside down! You may have done this for a good reason. I take it your case does not have intake vents where the PSU is?

My PSU is also mounted 'upside down'. I reckon it’s pretty pointless unless you have the bottom of your case cut out to allow air inside.

I have 2 front intakes, and then it gets exhausted out the back of the case through the PSU.

There’s no right or wrong way to mount a PSU imo.
 
yeah it has vents benneth the psu. i heard its best to mount it with the fan up

Where did you hear that? The PSU fan takes air in same with your graphics card and they are so close together, it aint good. The PSU is suppossed to take cool air in from the bottom of the case and keeps itself cool.
 
How do you guys keep your cases so clean inside? Dust filters can only do so much, surely? Plus I notice a lot of you aren't using them anyway?
 
I think that finishes it. Blacked up the main remaining bits of the power cables.

mg2296.jpg

mg2289.jpg

mg2291b.jpg

mg2290.jpg

mg2298.jpg


mg2283.jpg

This was great memory, I loved watching those flashing LED's. ¬_¬ Not into LED's these days.
 
Some sexy looking builds around. :) Wish I could get my cables looking that good but my Storm Scout is a bit difficult to cable manage with no extenders lol... and I refuse to pay £6+ for NZXT black extension although they do look fantastic. =(
 
A slight improvement over my last post - the inside of the case isn't pretty, but then it is rarely seen so I'm not too fussed. Wires were routed the way they are for airflow rather than aesthetics (And because I was bored).


IMG_1023 by mikehiow, on Flickr
 
Back
Top Bottom