• Notice regarding image hosts and attachments. See here.

Software to test temps, load etc?

Yeah, remove the CPU cooler, remove all the thermal paste. Re apply thermal paste then re sit the heatsink :)
 
how much paste is enough? i put a small blob (about 5mm across) in the middle and then installed HS onto it, without spreading it first (as advised in Noctua manual).

Better to spread it first? Am I using too much/little?
 
I rubbed my paste in with my finger... But if it says not to in the manual then don't :P

I use speedfan and realtemp :)
 
ok gotta reseat HS and apply paste again....

gotta spread it using finger in plastic bag this time apparently!

bb in a bit. hopefully with better temps!

current temps: 51C idle. max 92C.
 
argh. fail.

removed as much paste as i could, reapplied thin layer evenly over surface, reseatted HS and plugged everything back in.

BIOS reports:

SYS - 37C
CPU - 36C
MCH - 43C

RealTemp Reports:

idle - 53C
load - well into early 80s.

still fubar?
 
got through to SS again - very helpful :)

changed vCore to 1.3 instead of 1.27500

Seems much more stable now. Able to run prime95 for some time. Going to let it run for about an hour then try some other tests.
 
noctua on i7 d0 overclocked to 4.0 by ocuk.

it's running stable now. it's passed prime for 1hr, IBT for 30 mins and i'm going to try OCCT now. also BIT isn't giving any CPU math errors, which is good news.

if it's stable does it matter if it gets to 90C?
 
by the way it's only prime that can get this thing up to 90C. IBT and others only reach mid 80s.

edit: OCCT takes it to 81C then fails. obviously doesn't want to run beyond that... the only test to fail so far at 1.3v.

edit: now IBT has taken it to 87C.
 
Last edited:
Back
Top Bottom