SSD Information
- Thread starter tidusjar
- Start date
Set the SATA controller to AHCI mode before installing Windows (assuming that's what you're doing).
Disconnect all other storage drives when installing Windows.
Connect the SSD to an Intel/AMD SATA 3 port if you have them (I can't see your sig. if it contains your spec.).
Run the WEI after installing so that Windows "knows" you have an SSD and sets it up properly (disabling degrag. etc.).
Disconnect all other storage drives when installing Windows.
Connect the SSD to an Intel/AMD SATA 3 port if you have them (I can't see your sig. if it contains your spec.).
Run the WEI after installing so that Windows "knows" you have an SSD and sets it up properly (disabling degrag. etc.).
Associate
- Joined
- 20 Oct 2009
- Posts
- 2,137
- Location
- Deepest, darkest Essex
The best advise I can give you is visit the manufactures forum site and follow the recommended setup and tweaking guides
http://forums.crucial.com/t5/Solid-State-Drives-SSD/bd-p/ssd
It's full of useful do's and dont's and will avoid making silly mistakes
http://forums.crucial.com/t5/Solid-State-Drives-SSD/bd-p/ssd
It's full of useful do's and dont's and will avoid making silly mistakes