SSD Trim while HDD's in RAID

  • Thread starter Thread starter Deleted member 70857
  • Start date Start date

Deleted member 70857

Deleted member 70857

I've got an SSD and some older HDD's.

I'd like to RAID 0 the HDD's but only if the SSD (which won't be in RAID array) will still be able to support TRIM.

It's a Samsung 840 Pro and would be on a Z170 board.
 
Are you going to be using raid 0?

did a little look online and came across this link

https://communities.intel.com/thread/105184

with the below quote.

This message was posted on behalf of Intel Corporation
The Intel® Z170 Chipset supports Intel® Rapid Storage Technology (Intel® RST), and Trim functionality in RAID 0 is supported with Intel® RST version 11.0 or greater.

For additional information about this topic, please review the following advisory:

Learn about the Advantages of TRIM and How to Use It with Your Intel® SSD
Click to expand...

so if the above site is correct, trim should work in raid 0 configuration.
 
Yes 2 HDD's in RAID 0
While the SSD is going to be the C drive on its own.
 
hornetstinger said:
RAID 0 for SSD is stupid. Basically e-peen.
Click to expand...

Not really, I understand that the performance gains will be next to zero, but the cost of a 2TB ssd was more than twice that of a single 1TB ssd when i wanted to buy. I have two 1TB ssd's stuck together in raid 0, not for performance but for capacity (just for my steam folder really).
 
I have just changed my setup.

I have 2 x Samsung 850s 250gb drives which I have stuck in to raid 0 so its one drive instead of two.

I have a third SSD for the OS.

when I run this is command prompt

fsutil behavior query disabledeletenotify

its set to 0 so TRIM is enabled if it was 1 then it would be disabled, this is on a x58 board using intel controller.

im using windows 7
 
You must log in or register to reply here.
Back
Top Bottom