Stupid question from me :)
- Thread starter darkBytes
- Start date
A couple of runs are not ideal, this because the gpu waterblock inlet hit the bottom rad run, and meant i had to swap some fittings around, and do a funky bend or two, will get the fittings i need and re-do a couple of runs , but as a first attempt at ever doing this , I am pretty happy.
I mentioned the really good mem t juntion temp but i have noticed the gpu hotspot temp is a bit high and has between a 15 and 20 delta between gpu hotspot and gpu temp, think conta t on the plate might not be ideal, though am loathed to resit, i might have to
(Gpu 65 at vs gpu hotspot at 83) cyberpunk 4k maxed for 2 hrs. Though practically silent thats high).
I mentioned the really good mem t juntion temp but i have noticed the gpu hotspot temp is a bit high and has between a 15 and 20 delta between gpu hotspot and gpu temp, think conta t on the plate might not be ideal, though am loathed to resit, i might have to
(Gpu 65 at vs gpu hotspot at 83) cyberpunk 4k maxed for 2 hrs. Though practically silent thats high).
Soldato
- Joined
- 21 Dec 2019
- Posts
- 8,024
- Location
- Planet Thanet
Think you should be looking at about 10c difference
From couple videos I saw
Though not sure if 20c is a you must redo it
Or a you probably should redo it amount
From couple videos I saw
Though not sure if 20c is a you must redo it
Or a you probably should redo it amount
I don't think I could ever go back to air. Once you've been spoiled by full water it's hard to go back.
@darkBytes you going to get some side fans fitted to bring some cool air into those rads a rear fan as a intake with both rads extracting (blowing out) air this will give u much better temps
Or have both banks of fans set as intake so they get fresh external air. No need to overcomplicate it with even more fans.
Tried that ended up with worse temps getting much better temps in the confiq I suggested I don't see 3 more fans a complication get some that daisy chain and its one more cable to a fan header. but I guess OP can try it out first and see what happens
So you got better temps with 3 fans feeding 2 radiators fresh air than each radiator drawing fresh air themselves? That makes no sense at all, so I'd venture there was something else going on.
Nonetheless, that's how your system behaves so it's all good, if a little weird.
the way you suggest my case would just heat up causing whole system temp to rise
it makes total sense to draw cold air in then through radiators taking heated air out the case if u had a 3090 and a 10900Kf u would understand.